Installation instructions
Unpacking
To ensure the best performance from your new AquaSmart™ clothes washer please follow the instructions below.
Removing the packaging
1Remove the outer packaging.
2Tilt the machine backwards and walk it off the bottom packer one foot at a time.
3Remove the bottom packer from under the machine by
pulling it out the front.
4Lift the lid and remove the bowl packer from the bowl.
5 | Remove the hoses and accessories. |
|
|
6 | Keep the bottom packer and bowl packer in case they are | Fig.1 Tilt washer backwards | |
| required for future transit. | ||
|
| to remove packer | |
Important!
Ensure that the bottom packer has been removed before operating your machine.
Installation
In your clothes washer you will find:
4 rubber inserts for the levelling feet (joined together).
1 hose guide.
2 white inlet hoses.
Pull hose 
through guide
(20 mm) maximum
Drain hose
1 | Carefully pull the drain hose out from the back of |
|
| the machine by pulling the exposed part of the |
|
| hose downwards and outwards. | Flex hose |
2 | To guide the drain hose over the tub or standpipe | |
| the hose guide MUST be fitted to the drain hose. | guide apart |
Standpipe 850 – 2400 mm
To prevent siphoning:
The drain hose should not extend more thanFig.2 Fitting the drain hose guide 20 mm from the end of the guide. The height of the
standpipe or tub should be between 850 – 2400 mm. The drain hose can be trimmed to length.
3Place the drain hose in the tub or standpipe.
Draining
Regularly check that your standpipe or tub is free from lint or other obstructions, which may affect how your machine works or may cause flooding.
In
