
APPENDIX
LAMP REPLACEMENT Indicator
When the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow. When the image become dark or the color of the image become unnatural, replacement of the Lamp is required.
Lamp Replacement
CAUTION
lFor continued safety, replace with a lamp assembly of the same type.
lAllow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
lDo not drop the lamp module or touch the glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp assembly.
1 | Turn off the projector and disconnect the AC plug. Allow |
| the projector to cool for at least 45 minutes. |
2 | Remove the Center Panel of the projector. Pull the lower |
| part first and remove the Panel. |
3 | Remove a screw with a screwdriver and remove the |
| Lamp Cover. |
4 | Remove 2 screws with a screwdriver and pull out the |
| Lamp Assembly by grasping the handle. |
5 | Replace the Lamp Assembly and tighten 2 screws. Make |
| sure that the Lamp Assembly is set properly. |
6 | Replace the Lamp Cover and tighten a screws, and |
| replace the Center Panel. |
| NOTE : Be sure to meet the Center Panel and the |
| projector at the upper part first, and set the |
| Center Panel securely. |
7 | Connect the AC Power Cord to the projector and turn the |
| projector on. |
8 | Reset the Lamp Replacement Monitor Timer (refer to the |
| section "Lamp Replacement Monitor Timer" below.) |
Remove a screw and the Lamp Cover.
Remove 2 screws and the Lamp Assembly by grasping the handle.
Pull the lower part
first and remove.CAUTION
Do not drop the screw inside of the cabinet.
Lamp Replacement Monitor Timer
Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops to lighting.
1 | Turn the projector on, and press the MENU button and the | |
| LEFT/RIGHT buttons to select SETTING | and press the SELECT (REAR CLICK) button (refer to the page 38). |
| Another dialog box SETTING MENU Menu will appear. | |
2 | Press the POINT DOWN button and a | |
| SELECT (REAR CLICK) button. The message of "Lamp replace monitor Reset?" is displayed. | |
3 | Select [Yes] to reset the Timer. |
|
Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.
42