ASSEMBLY
Door
Hinge
24
• Fit a hinge over the top end of the door.
Hint: Each hinge is designed to fit one way. If the hinge does not fit, try the other hinge.
•Insert three #10 x 3/4" (1,9 cm) screws into the hinge and tighten.
•Repeat Assembly steps 23 and 24 to assemble the other door and hinge.
Loosen These
Screws
25DASH VIEW
•Locate the sound box on the dash. Loosen the screws in the battery compartment door. Remove the battery compartment door.
•Insert three, new “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer battery life.
•Replace the battery compartment door and tighten the screws.
•When sounds become faint or stop, it’s time for an adult to change the batteries! Please refer to page 19 for sound box operation.
1,5V x 3
“AA” (LR6)
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
•Do not mix old and new batteries or batteries of different types: alkaline, standard
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of
•Never
•Use only batteries of the same or equivalent type, as recommended.
•Do not charge
•Remove rechargeable batteries from the product before charging.
•If removable, rechargeable batteries are used, they are only to be charged under adult supervision.
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
•This device complies with Part 15 of the FCC Rules.
•Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
14 |
