Fitness Quest 7.0r manual Handlebar Tube Assembly, Seat Carriage Assembly, Foot Pedal Assembly

STEP 3 – Handlebar Tube Assembly

a) Remove the two Allen Bolts, Washers and Phillips Screw from

the Handlebar Tube.
b) Slip the Handlebar Tube Cover onto the Handlebar Tube as shown.	handlebar
The Handlebar Tube should lean back towards the back of unit.	tube

opening in

handlebar tube

towards back

c)Remove the wire tie from the wires inside the Main Frame Assembly where the Handlebar Tube will go. Attach the three wires from the Main Frame Assembly to the three wires coming out the bottom of the Handlebar Tube.

d)Insert the Handlebar Tube into the Main Frame Assembly, tucking the wires down into the Main Frame Assembly. Reinsert the Allen Bolts and Washers you removed in (a). Be careful not to

pinch the wires. NOTE: Gently pull the wires up from the

top of the Handlebar Tube to prevent any slack in the	3a
wires at the base of the Handlebar Tube. Hand tighten.

phillips

screw

3d

3b

handlebar tube cover

e)	Secure the Handlebar Tube in place with the three			remove allen
				bolts & washers
	Allen Bolts, Washers and Nylon Nuts from the Fastener			3d
	Pack. Tighten with the Wrench provided. Also tighten
				re-insert allen
	the bolts used in step (d).			bolts & washers
				from step a
f )	Let the Handlebar Tube Cover	M8 x 60mm allen bolts,
	slip into place. Push it down	M8 washers and M8 nylon nuts		allen bolts,
	gently until it clicks. Secure in			washers & nuts
			3e	from fastener
	place with the Phillips Screw			pack
	you removed in (a).

3c

back of unit

main frame assembly

STEP 4 – Seat Carriage Assembly

a)Remove the Plastic Stoppers and the two small Phillips Screws at the back of the Seat Carriage Tube. Slide off the Carriage End Cap letting it gently hang.

b)Holding the Seat Carriage Assembly by the front of Seat Cushion and the top of the Back Rest, slide it onto the Seat Carriage Tube. Lift up on the Seat Carriage Locking Knob and slide the Seat Carriage Assembly on the Seat Carriage Tube until the Seat Carriage Locking Knob locks into a slot.

STEP 5 – Foot Pedal Assembly

The Foot Pedals and the Foot Pedal Cranks are marked “L” and “R”.

Using the Wrench provided, attach the left Foot Pedal to the left Crank rotating the Wrench counter-clockwise.

Do not try to turn clockwise. You will strip the threads.

Attach the right Foot Pedal to the right

c)Replace the Plastic Stoppers, Carriage End Cap and Phillips Screws you removed in (a).

d)Plug the wire from the back of the Seat Carriage Tube into the wires coming from the Handlebar on the lower back of the Seat Carriage Assembly.

seat carriage locking knob

seat carriage

4a 4c

plastic stoppers

phillips

Crank rotating the Wrench clockwise.

left foot

pedal

left

crank

left side shown

looking from the

tube

4b

screw

4d	carriage
	end cap
	wire

back of the unit	“L” & “R”
	markings are
	located on the
	ends of the
	pedal shaft.

7