In this mode nothingappears on thealphanumeric portion of the display. Use
this mode if you areonly interested in the latest measurements and want to sim-
plify the appearance of the display.
The message “Prb cal expired”,“Mtr cal expired”, “Recharge Needed”, or
“Probe is locked”may be displayed. See Section 11.1.
7.2 Min/Max Mode
This mode is identified by “Min/Max” that temporarily appears on the display.
In this mode the maximum and minimum measurements taken since the last
time thefunction was cleared appears on the display. The minimum appears on
theleft and the maximum appears on the right. The resolution of the displayed
valuesmay be changed using the Resolution mode (see Section 7.7). Pressing
the CLR button at anytime while in this mode clears the minimum and maxi-
mum valuessettin g them to the lastmeasur ement. Both the minimum and max-
imum are resetto 0°C (32°F) when the instrument is powered up.
The message “Prb cal expired”,“Mtr cal expired”, “Recharge Needed”, or
“Probe is locked”may be displayed. See Section 11.1.
7.3 Hold Mode
This mode is identified by “Hold” that temporarily appears on the display.
In this mode thedata stored in one of the hold registers appears on the display.
There are six hold registers.Th ereso lution of the Hold registervalues may be
changed using the ResolutionMode (see Section 7.7). The Up and Down bu t-
tons areused to select a desired hold register for viewing. The ENT button is
used to store a measurement in thenext available register.
The message “Prb cal expired”,“Mtr cal expired”, “Recharge Needed” , or
“Probe is locked”may be displayed. See Section 11.1.
7.4 Delta(x) Mode
This mode is identified by “Delta(x)” that temporarily appears on the display.
In this mode the deltabetween the measurement and a previously stored refer-
ence valueappears on the right side of the display. The reference value appears
on the left. The resolutionof the reference valuemay be changed using the
Resolution mode (see Section 7.7) if necessary.The ENT button sto res the
present measurement as the reference value.
The message “Prb cal expired”,“Mtr cal expired”, “Recharge Needed” , or
“Probe is locked”may be displayed. See Section 11.1.
27
7 Display Functions
Min/Max Mode