General

Safety

General

1.This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the product by a person responsible for their safety. Children should be supervised to ensure that they do not play with the product. Local regulations may restrict the age of the operator.

2.Never allow children or people unfamiliar with the instructions to use the machine.

3.Stop using the machine while people, especially children, or pets are nearby.

4.Only use the product in the manner and for the functions described in these instructions.

5.Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine.

6.The operator or user is responsible for accidents or hazards occurring to other people or their property.

Electrical

1.The British Standards Institute recommend the use of a Residual Current Circuit Device (R.C.D.) with a tripping current of not more than 30mA. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it.

2.Before use, examine cable for damage, replace it if there are signs of damage or ageing.

3.Do not use the product if the electric cables are damaged or worn

4.Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one.

5.Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your product.

6.Keep cable away from product, always work away from the power point mowing up and down, never in circles.

7.Do not pull cable around sharp objects.

8.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.

9.Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable.

10.Always wind cable carefully, avoiding kinking.

11.Never carry the product by the cable.

12.Never pull on the cable to disconnect any of the plugs.

13.Use only on AC mains supply voltage shown on the product rating label.

14.Flymo Products are double insulated to EN60335. Under no circumstance should an earth be connected to any part of the product.

Preparation

1.While using your product always wear substantial footwear and long trousers.

2.Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade.

3.Before using the product and after any impact, check for signs of wear or damage and repair as necessary.

4.Replace worn or damaged blades together with their fixings in sets to preserve balance.

Use

Use the product only in daylight or good artificial

1.

2.

light.

Avoid operating your product in wet grass,

3.

where feasible.

Take care in wet grass, you may lose your

4.

footing.

On slopes, be extra careful of your footing and

5.

wear non-slip footwear.

Use across the face of slopes, never up and

6.

down.

Exercise extreme caution when changing

7.

direction on slopes. Walk never run.

Using on banks and slopes can be dangerous.

8.

Do not use on banks or steep slopes.

Do not walk backwards when operating, you

9.

could trip.

Never cut grass by pulling the product towards

10.

you.

Switch off before pushing the mower over

11.

surfaces other than grass.

Never operate the product with damaged guards

12.

or without guards in place.

Keep hands and feet away from the blade at all

 

times and especially when switching on the

13.

motor.

Do not tilt product when the motor is running,

 

except when starting and stopping. In this case,

 

do not tilt more than absolutely necessary and

 

lift only the part which is away from the operator.

 

Always ensure that both hands are in the

 

operating position before returning the product

14.

to the ground.

Do not put hands near the grass discharge

15.

chute.

Never pick up or carry a product when it is

16.

operating or still connected to the mains supply.

Remove the plug from the mains :

-before leaving the product unattended for any period;

-before clearing a blockage;

-before checking, cleaning or working on the appliance;

-if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition.;

-if the product starts to vibrate abnormally. Check immediately. Excessive vibration can cause injury.

Maintenance and storage

1.Caution: Do not touch rotating blade(s)

2.Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition.

3.Check the grassbox frequently for wear or deterioration.

4.Replace worn or damaged parts for safety.

5.Only use the replacement blade, and blade bolt specified for this product.

6.Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine.

7.Store in a cool dry place and out of reach of children. Do not store outdoors.

8.Allow the product to cool for at least 30 minutes before storing.

PAGE 3

Page 4
Image 4
Flymo 340XC, 360XC, 420XC manual Safety, Page, General, Electrical, Preparation, Maintenance and storage

340XC, 420XC, 420, 360, 360XC specifications

The Flymo EASICUT 500 and EASICUT 420 are innovative cordless electric hedge trimmers designed for maintenance and care of hedges and shrubs in residential gardens. These models are recognized for their efficiency, maneuverability, and user-friendly features, making garden upkeep a less daunting task.

One of the standout features of the Flymo EASICUT 500 and EASICUT 420 is the lightweight design, allowing users to handle the trimmers with ease even during extended periods of use. Weighing significantly less than many traditional hedge trimmers, both models provide comfort and reduced fatigue, making them ideal for both professional landscapers and home gardeners.

Both trimmers are equipped with laser-cut precision blades, which ensure a clean and smooth cut. This not only enhances the appearance of hedges and shrubs but also promotes healthier plant growth by preventing jagged edges. The EASICUT 500 boasts a blade length of 50 cm, while the EASICUT 420 has a slightly shorter 42 cm blade, catering to different garden sizes and trimming requirements.

The trimmers feature ergonomic handles designed for optimal grip and control. This thoughtful design reduces the likelihood of strain and discomfort during operation. Furthermore, they include a safety switch that ensures the device only operates when intended, enhancing user safety.

Powering the Flymo EASICUT series is an efficient battery system that delivers impressive run time with a quick charging capability. This cordless technology frees users from the hassle of tangled cords, allowing for unrestricted movement around the garden. The EASICUT series also has a low noise operation, making it perfect for use in residential areas without disturbing neighbors.

Additionally, the EASICUT models are designed with a protective blade guard, ensuring safe storage and transportation. This feature further extends the longevity of the blades by preventing accidental damage.

Overall, the Flymo EASICUT 500 and EASICUT 420 are excellent choices for those seeking efficient, lightweight, and user-friendly hedge trimmers. With their advanced technology, safety features, and precision cutting capabilities, these trimmers are well-suited to help you maintain a beautiful and healthy garden with ease.