NAT/Route mode installation Starting the setup wizard
FortiGate-500A Installation Guide 01-28005-0101-20041015 33
Starting the setup wizard
1In the web-based manager, select Easy Setup Wizard.
Figure 8: Select the Easy Setup Wizard
2Follow the instructions on the wizard pages and use the information that you gathered
in Table5 on page 26 and Table 7 on page 32 to fill in the wizard fields.
3Select the Next button to step through the wizard pages.
4Confirm the configuration settings, and then select Finish and Close.
You are now finished the initial configuration of the FortiGate unit.
Antivirus
High Create a protection profile that enables virus
scanning, file blocking, and blocking of oversize
email for HTTP, FTP, IMAP, POP3, and SMTP. Add
this protection profile to a default firewall policy.
Medium Create a protection profile that enables virus
scanning, for HTTP, FTP, IMAP, POP3, and SMTP
(recommended). Add this protection profile to a
default firewall policy.
None Do not configure antivirus protection.
Select one of these security levels to protect your network from viruses.
Table 7: Setup wizard settings
Note: If you change the IP address of the interface you are connecting to, you must connect
through a web browser again using the new address. Browse to https:// followed by the new IP
address of the interface. If the new IP address of the interface is on a different subnet, you may
have to change the IP address of your computer to the same subnet.
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For each server located on the
network connected to Port 1 the FortiGate unit adds a Port2->Port1 firewall policy.