HPF (High pass filter)
40Hz to 300Hz,
The cutoff frequency is continuously sweepable.
Slate microphone / slate tone
Slate tone: 1kHz
Slate microphone: built in the unit
Level meter
VU and peak level meters
Stereo/mono metering selectable
Limiter
Attack time: approximately 5 msec.
Release time: approximately 200 msec.
Threshold level: +6dBu or +12dBu at +4dBu output level
Ratio: 3:1 or 5:1
*Threshold level and ratio can be selected using the status mode.
General
External dimensions:
210 (W) x 57 (H) x 156 (D) mm (Including protrusions)
Weight:
approximately 1.2kg (not including the internal batteries)
Power:
Internal batteries: Eight AA batteries (alkaline: 12V,
nickel hydride: 9.6V)
Power requirement: DC7.2 to 12V
External power supply: Optional AC adaptor
Recommended external battery voltage: DC12 to 24V
Power requirement: DC9 to 24V
Power consumption:
Approximately 4.0W
Operation condition:
Temperature:
Humidity: 85% or less (no moisture condensation)
Power voltage deviation: DC9V to 24V
Supplied accessories:
Battery box, Owner’s manual
Operation time with batteries (for reference)
Measurement condition: 20º C temperature, 60% humidity
Battery type | Microphone power supply | ||
OFF (DM) | ON (P48 x 3) | ||
| |||
Alkakine (LR6) | Approx. 7.0 hours | Approx. 5.0 hours | |
Approx. 7.5 hours | Approx. 6.5 hours | ||
Approx. 9.0 hours | Approx. 7.5 hours | ||
Measurement condition: 0º C temperature, saturated humidity
Battery type | Microphone power supply | ||
OFF (DM) | ON (P48 x 3) | ||
| |||
Alkakine (LR6) | Approx. 3.5 hours | Approx. 2.5 hours | |
Approx. 7.5 hours | Approx. 6.0 hours | ||
Approx. 9.0 hours | Approx. 7.0 hours | ||
Measurement condition: +45º C temperature, 60% humidity
Battery type | Microphone power supply | ||
OFF (DM) | ON (P48 x 3) | ||
| |||
Alkakine (LR6) | Approx. 7.5 hours | Approx. 6.0 hours | |
Approx. 8.0 hours | Approx. 6.5 hours | ||
Approx. 9.5 hours | Approx. 8.0 hours | ||
<Note 1>: The operation time data shown above is for refer- ence only. The actual operation time depends on the opera- tional condition or circumstance.
<Note 2>: The more time the nickel hydride battery is charged or discharged, the maximum capacity decreases.
<Note 3>: The data shown above is measured using nickel hydride batteries that has been fully charged just before. Because a nickel hydride battery
<Note 4>: Use eight batteries of the same type and same capacity.
<Memo>: Lower the operation temperature is, shorter the life of a primary battery (e.g alkaline) is.
When you use the unit in a place where temperature is low, it is recommended to use nickel hydride batteries.
22
