Fostex VF80 owner manual Setting the Record Protect function Rec Protect, Free, Vari

SETUP mode

1

2

Select “Slave Type” in the menu selection display and press the [ENTER/YES] key.

The currently set slave type will flash. “Vari” will be flash in the initial setting.

flashing

Select the desired slave type with the [JOG] dial and press the [ENTER/YES] key.

It will be set to the selected slave type.

	This is the mode whereby after chase
	locking, it will free run by the internal
Free	clock of VF80 or the digital in clock
	from the external equipment should
	the time drift away from that of the
	master.
	This is the mode whereby after chase
	locking, it will constantly run by vari-
Vari	pitch so that the time does not drift
	away from that of the master by
(Initial setting)
	compensating the phase drift.
	However, if digital in has been set, it
	will operate the same as for “Free.”
	This is the mode whereby after chase
	locking, it will free run by the S/P DIF
SPDIF	clock only when there is S/P DIF digital
	signals from the master.
	However, if digital in has been set, that
	clock will have priority.

3Press the [EXIT/NO] key (or STOP key) to exit from the SETUP mode.

Setting the Record Protect function [“Rec Protect”]

The “Setting the Record Protect function” menu allows you to turn the Record Protection function On or Off. When this function in turned “On”, you cannot record, paste, or erase data. Use this function to protect your important data from being accidentally erased.

• Initial setting:	[Off]
• Options:	[On] or [Off]

*You can set the mode for each Program individually.

*The settings can be saved and loaded as part of the song data.

*The settings are maintained after you turn off the power to the VF80.

<Note>

When recording is disabled (“On”) and you try to record, paste, or erase data, the VF80 displays “Protected!” for a second, indicating that you cannot perform the operation. To perform the operation you need to enable recording (“Off”).

1

Select “Rec Protect” in the menu selection display and then press the [ENTER/YES] key.

The presently set item (On or Off) will flash. “Off” will flash in the initial setting.

flashing

2

Select “On” or “Off” with the [JOG] dial and then press the [ENTER/YES] key.

It will be set to the selected item (On or Off).

Selecting “Off” enables recording; you can record, paste, and erase data.

Selecting “On” disables recording; and you cannot record, paste, or erase data.

3

Press the [EXIT/NO] key (or STOP key) to exit from the SETUP mode.

129