Fostex VF80 owner manual Undo/redo of Erase

Recorder Functions

•To set editing points by marks:

Press the [TIME BASE SEL] key.

Each data field for the Start and End points changes to show the current option by mark as shown below.

Use the [CURSOR / ] keys to highlight the field for the desired point, and press the [ENTER/YES] key.

The field starts flashing.

Use the [JOG] dial to select the desired mark and press the [ENTER/YES] key.

The editing point is set to the selected mark.

<Note>

This operation can be performed only when any mark is set. When no mark is set, "00:ABS 0" is the one and only option for each point.

6Press the [UNDO/REDO/F3] key while holding down the [SHIFT] key.

The erase function is performed. When finished, "Com- pleted!" appears on the screen.

<Hint>

You may use the [CURSOR ] to highlight "EXE" and press the [ENTER/YES] key to perform the function, instead of pressing the [UNDO/REDO/F3] key while holding down the [SHIFT] key.

Undo/redo of Erase

You can undo an erase operation, as well as redo it (undo the undo operation).

•By pressing the [UNDO/REDO] key after completing the erase operation, you can return the track(s) to the condition before performing the erase operation.

•By pressing the [UNDO/REDO] key just after performing the undo operation, you can undo the undo operation and return the track(s) to the condition after performing the erase operation.

Note the following for performing the undo/redo op- eration.

<Notes>

You can undo or redo only when the recorder is stopped. If you carry out any of the following after performing the erase operation, you cannot undo/redo the erase operation.

1.Making a new recording 2.Performing a new editing

3.Letting the recorder run in playback (or recording) mode and pass through the auto punch-in point while the auto punch mode is active

4.Turning off the power of the VF80

5.Performing any of the program operations (select, rename or delete).

67