Fostex owner manual Replacing a hard disk, Operation Confirmed HD List for the VF80

About the hard disk storage device

5Select the format type with the [CURSOR/] key. Then press the [ENTER/YES] key.

The format type selected is set and “Sure?” flashes.

Flashing

6Press the [ENTER/YES] key while the [RECORD] key is depressed.

If the “Standard” format is selected and executed, the formatting process takes place while showing the progress of the good sectors (Good ***MB) on the disk, bad sectors on the disk (Bad ***MB) and remainder (Remain ***MB).

Nothing can be done during the formatting process. Please wait for a while until the process is completed.

When the hard disk is successfully formatted (formatting completed), the number of sectors and noncontiguous sectors are shown after formatted, then “Completed!” lights up. Formatting is completed instantaneously if either “Erase” or “Quick” is selected and executed.

For this reason, the “Completed!” message lights up without showing the progress status while formatting is taking place.

7Press the [EXIT/NO] key (or [STOP] key) to escape from the SETUP mode.

The Normal Screen appears indicating the beginning of the program (P01) that is automatically created after formatting the hard disk.

Replacing a hard disk

The user can immediately start recording with the VF80. Note that the current hard disk can also be replaced with another model for use with the VF80. (However, please only use hard disks that Fostex recommends.)

<Operation Confirmed HD List for the VF80>

The updated information on the operation- confirmed HD and backup media for VF80 is mentioned in the following Fostex international web site.

<http: // www. fostex.co.jp/int/index.htm>

For those who are unable to check our web site, please contact the Fostex distributor in your territory.

<Warning>

This section describes the procedures to replace the hard disk. However, we recommended that the customer ask the Fostex Customer Service Department to replace the VF80 hard disk. Note that the product is not warranted for any malfunctions that may occur after the customer replaces the hard disk on their own. Also note that Fostex will not be held liable for any accidents that may occur during the replacement process or any hard disk damages, if the customer decides to replace their own hard disk on their own.

<Precautions Upon Replacement>

•Always turn OFF the power of the VF80 and unplug the power plug from the electric outlet when replacing the hard disk.

•Always place the hard disk on a flat and stable platform during the replacement process. Place a soft cloth under the unit to protect the product from scratching. Gloves are recommended to prevent any hand injuries.

<Precautions Upon Handling the Hard Disk>

•A hard disk is an extremely sensitive precision device. Never expose the hard disk to “strong shocks” when replacing, assembling or handling. Never leave the hard disk by a device that generates strong magnetic fields.

•Always set the DIP switch and Jumper of the newly assembled hard disk to the “Cable Select” setting. The hard disk will not operate normally if the setting is set to “Slave” or “Master” when the hard disk is assembled. Refer to the User’s Manual of the hard disk for more details on the DIP switch and Jumper settings.

•Note that the connector of some hard disks may be stiff, and thus make it difficult or impossible to insert or connect. Never apply excessive force to insert the connector in such case. Always make a point to gently insert the connector. Failure to do so may result in unexpected injuries or damage the hard disk.

21