![](/images/new-backgrounds/1189156/18915667x1.webp)
Foundry IronPoint 250 Installation Guide
specific antenna and cable combinations. For this reason, you must consult with a professional installer who is trained in RF installation and knowledgeable in the local regulations prior to connecting an external antenna to your wireless radio product. It is the responsibility of the end user to ensure that the antenna installation complies with the local radio regulations.
To install an external antenna:
1.Connect the external antenna’s Reverse SMA connector to the access point’s external antenna connector. Connect 2.4 GHz antennas to the connector labeled "802.11b/g" and 5.0 GHz antennas to the connector labeled "802.11a."
Figure 4-5. Connecting the External Antenna
|
|
| Lock |
|
|
| 802.11b/g |
| POE In | Reset | Console |
|
| ||
802.11a | DC 48V / 0.38A |
|
|
|
|
| |
External Antenna |
|
| External Antenna |
|
| Connector | |
Connector |
|
| |
|
| (802.11b/g Radio) | |
(802.11a Radio) |
|
| |
|
|
|
2.Set the Antenna Mode for the radio interface to "external" using the CLI or Web interface.
3.Enable the radio interface using the CLI or Web interface.
Powering Up the Access Point
Prepare the access point for power up by doing the following:
1. Connect the
Note: The IronPoint access point also supports power over Ethernet (PoE) to obtain its power from the
2. Connect the other end of the
© 2007 Foundry Networks, Inc. | August 2007 |