Franklin 5870206300 Installation Procedure

Installation Procedure

1. Disconnect electrical power at the main breaker.

2. Drain the system (if applicable).

3. Install the pressure sensor and pressure shut-off sensor at the

pressure tank tee downstream of the pressure tank (the pressure

tank should be between the pressure sensor and the pump). The

sensors have a ¼-18 National Pipe Thread (NPT) connection.

The pressure sensors should not be installed in an inverted

orientation (up-side down). Make sure the pressure sensor and tank

are not located more than 3 feet off the main piping.

4. Install the unit to the wall using four mounting screws (not included) as

shown in Figure 1 below. Remove the SubDrive lid by removing the eight

lid screws.

Mounting Screw Locations

(User Supplied Quantity 4)

Lid Screws (Included Quantity 8)

Contents

Main Contents Tables Figures Page Description and Features Included Items G E 01000 SubDrive Extended Warranty Registration How It Works DE B C Constant Pressure Motor Soft Start System Diagnostics Unique Features Pump Sizing Drive Con guration Underload Sensitivity for Shallow Wells Configuration Switch POS Underload Sensitivity Before Getting Started Controller Location Selection CORRECT INCORRECT Circuit Breaker and Wire Sizing Quick Reference Guid e P/N 587 020 6300 NOTICE e SubDrive300 WARNING Pressure Setting Guide Pressure Tank Installation Procedure Figure 1: Mounting Screws Wiring Connections Figure 2: Motor Lead Connections Figure 3: Power and Pressure Sensor Connections Figure 4A: Pressure Sensor Figure 4B: Pressure Shut-off Sensor Start-Up and Operation Leaky Systems Speci cations NOTES: Page Diagnostic Fault Codes # of Flashes Fault Possible Cause Corrective Action 1 2 6 3 4 5 System Troubleshooting Guide Symptom Possible Cause Corrective Action Underload Smart Reset Off Time (Min.) Run Time (Min.) Over-Temperature Foldback