Chassis Install Preparation
Check to be sure the wall sleeve, extension (if used), grille, and drain kit are installed properly before chassis installation.
1. Remove the weatherboard and center support from the sleeve (if | NOTE: | To avoid breaking the door or hinge pins, do not apply excessive |
still in place). Be sure an outdoor grille is attached. |
| force when installing. |
Figure 18 |
WALL SLEEVE |
WEATHERBOARD |
CENTER SUPPORT |
FRP015 |
Figure 19 |
PIN |
CONTROL |
DOOR |
INSERT PIN |
IN THIS LOCATION |
FRP016 |
NOTE: Use a wall sleeve adapter kit (PXSE) if installing a
WARNING
Suffocation Hazards
Keep bag away from babies and children.
Do NOT use in cribs, beds or playpens. Destroy immediately after opening. This bag is NOT a toy.
Failure to do so can result in personal injury and/or death.
IMPORTANT: When installing a Friedrich PTAC into an existing sleeve, it is important to ensure that the unit is installed completely. Inspection of the air seal between the condenser air baffles and around the indoor mounting flange is recommended.
In some cases additional gaskets or baffling may be required.
2.Remove the front cover contained in a protective plastic bag from chassis. Remove the bag and dispose of it properly..
.
If the control door is not installed, follow these steps:
a.From the front cover, slide the right control door pin into the hole on the right side of the front cover.
b.Slide the left door pin into the hole on the left side of the front cover opening.
c.Snap cover into place.
16
