Accessories
New Construction Accessories
PDXWS. | WALL SLEEVE Galvanized zinc coated steel is prepared in an | |
. | then powder coated with a polyester finish and cured in an oven for exceptional | |
. | durability. The wall sleeve is insulated for sound absorption and thermal ef- | |
. | ficiency, 16" High x 42" Wide x 13 3/4" Deep.. | |
. | . |
|
PDXWSEXT | DEEP WALL SLEEVE EXTENSION For use when the wall is thicker than 13 | |
| 1/4”deep. The wall sleeve may be special ordered through your Sales Represen- | |
| tative and will be cut to your specific depth requirements.. | |
PXGA | GRILLE Standard, stamped aluminium, anodized to resist chalking and oxidation. | |
|
|
|
PXAA. | ARCHITECTURAL GRILLES Consist of | |
PXBG. | PXAA – Clear, extruded aluminum | |
PXSC | PXBG – Beige acrylic enamel | |
| PXSC – Also available in custom colors. | |
PXDR10 | CONDENSATE DRAIN KIT Attaches to the bottom of the wall sleeve for internal | |
| draining of condensate or to the rear wall sleeve flange for external draining. | |
| Recommended on all units to remove excess condensate. Packaged in quantities | |
| of ten. | |
|
| |
PXSB | DECORATIVE SUBBASE Provides unit support for walls less than six inches | |
| thick. Includes leveling legs, side filler panels and mounting brackets for electri- | |
| cal accessories. Accepts circuit breaker, power disconnect switch, or conduit kit. | |
|
| |
RT6 | DIGITAL REMOTE WALL THERMOSTAT Single stage cool, single stage heat | |
| for PDE models or single stage cool, dual stage heat for PDH model thermostat | |
| features high/low fan speed switch. Thermostat is hard wired and can be battery | |
| powered or unit powered. Features backlit display and multiple configuration | |
| modes. For use on | |
|
| |
PDXRTA | REMOTE THERMOSTAT ESCUTCHEON KIT This kit contains ten escutcheons | |
| that can be placed over the factory control buttons when a remote wall mounted | |
| thermostat is used. The escutcheon directs the guest to the wall thermostat for | |
| operation and retains the LED window to display error codes and diagnostic | |
| information. | |
|
| FRP029 |
|
| |
PXSE | SLEEVE EXTENSION RETROFIT KIT Galvanized zinc coated steel, 2.4" sleeve | |
| extension attached to the room side of the sleeve to allow for the installation of a | |
| ||
|
| |
PDXDAA | LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP unit and provides a | |
| transition to direct up to 35% of the total CFM to a secondary room, either left or | |
| right of the unit. Kit includes duct plenum with discharge grille and internal baffle, | |
| adapter and end cap. |
|
PDXDEA | LATERAL DUCT EXTENSION A | |
| the left or right side of the duct adapter. The extension can be cut to length by the | |
| installer. Maximum allowable straight extension is 15 feet. |
30