SWING OPERATION
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING button (Fig. 6
The SWING Display (Fig. 7
In this mode, the Air Flow Direction Louvers will swing automatically to direct the air flow both up and down.
To stop SWING Operation
Press the SWING button (Fig. 6
The SWING Display (Fig. 7
Airflow direction will return to the setting before swing was begun.
About Swing Operation
During cooling/Dry mode : | Swings between 1 and 4. | |
During heating mode | : | Swings between 4 and 6. |
●The SWING operation may stop temporarily when the air conditioner’s fan is not operating, or when operating at very low speeds.
COIL DRY OPERATION
The Indoor unit can be dried by pressing the COIL DRY button on the Remote Control Unit so as to avoid going moldy and restrain the breed of bacterium.
The COIL DRY operation will operate for 90 minutes after pressing the COIL DRY button and it will stop automatically.
To select COIL DRY Operation
Press the COIL DRY button (Fig. 6
The COIL DRY Display (Fig. 7
To cancel COIL DRY Operation
Press the START/STOP button (Fig. 6
Operation.
The indoor unit COIL DRY Indicator Lamp (yellow) (Fig.1
About COIL DRY Operation
●Press the COIL DRY button again during COIL DRY Operation, COIL DRY Opera- tion can be reset.
●The COIL DRY Operation cannot get rid of the existed mold or bacterium, and it has no sterilization effect either.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
To stop operation, press the MANUAL AUTO button (Fig. 2
●When the air conditioner is operated by the controls on the Main Unit, it will operate under the same mode as the AUTO mode selected on the Remote Control Unit (see page 6).
●The fan speed selected will be “AUTO” and the thermostat setting will be standard (76 °F).
