Friedrich MW09Y3H, MW12Y3H manual Operation, En-6, When set to AUTO, Heating, Cooling

OPERATION

To Select Mode Operation

1	Press the START/STOP button (Fig.6 b-9).
	The indoor unit’s OPERATION Indicator Lamp (green) (Fig. 3 a-5) will light.
	The air conditioner will start operating.
2	Press the MODE button (Fig.6 b-2) to select the desired
	mode.

Each time the button is pressed, the mode will change in the following order.

sAUTO		s COOL	s DRY
	HEAT t			FAN t

About three seconds later, the entire display will reappear.

To Set the Thermostat

Press the SET TEMP. button (Fig. 6 b-4).

button: Press to raise the thermostat setting. button: Press to lower the thermostat setting.

●Thermostat setting range:

AUTO	64-88 °F
Heating	60-88 °F
Cooling/Dry	64-88 °F

The thermostat cannot be used to set room temperature during the FAN mode (the temperature will not appear on the Remote Control Unit’s Display).

About three seconds later, the entire display will reappear.

The thermostat setting should be considered a standard value, and may differ somewhat from the actual room temperature.

Example: When set to COOL.

Example: When set to 80°F.

To Set the Fan Speed

Press the FAN button (Fig. 6 b-8).

Each time the button is pressed, the fan speed changes in the following order:

sAUTO s HIGH s MED sLOW sQUIET

About three seconds later, the entire display will reappear.

When set to AUTO:
Heating:		Fan operates so as to optimally circulate warmed air.
		However, the fan will operate at very low speed when the temperature
		of the air issued from the indoor unit is low.
Cooling :		As the room temperature approaches that of the thermostat setting,
		the fan speed becomes slower.
Fan	:	The fan runs at the low fan speed.	Example: When set to AUTO.

The fan will operate at a very low setting during Monitor operation and at the start of the Heating mode.

En-6