Fig. 1 Indoor Unit
●When kept on pressing the MANUAL AUTO button for more than 10 seconds, the forced cooling operation will start.
●The forced cooling operation is used at the time of installation.
Only for authorized service personnel's use.
●When the forced cooling operation starts by any chance, press the START/ STOP button to stop the operation.
| ● If the TIMER indicator lamp flashes when |
| the timer is operating, it indicates that a |
| fault has occurred with the timer setting |
| (See Page 15 Auto Restart). |
COIL DRY Indicator Lamp (yellow) | |
|
|
Intake Grille (Fig. 4) | |
Front Panel | |
Air Filter | |
Airflow Direction Louver | |
| (behind Airflow Direction Louver) |
Drain Hose |
Fig. 5 Outdoor Unit
Fig. 6 Remote Control Unit 
/ 
)
/ 
) button
●This button is used when installing the air conditioner, and should not be used under normal conditions, as it will cause the indoor unit’s thermostat function to operate incorrectly.
●If this button is pressed during normal operation, the indoor unit will switch to test operation mode, and the Indoor Unit’s OPERATION Indicator Lamp and TIMER Indicator Lamp will begin to flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air conditioner.
