Friedrich MW12Y3H, MW09Y3H manual Preparation

PREPARATION

Load Batteries (AAA/R03/LR03 ⋅ 2)

1	Press and slide the battery compartment lid on the re-
	verse side to open it.
	Slide in the direction of the arrow while pressing the mark.
2	Insert batteries.
	Be sure to align the battery polarities (			) correctly.
3	Close the battery compartment lid.
Set the Current time
1	Press the CLOCK ADJUST button (Fig. 6 b-14).
	Use the tip of a ball-point pen or other small object to press the button.
2	Use the TIMER SET (		/	) buttons (Fig. 6 b-13) to
	adjust the clock to the current time.
		button: Press to advance the time.
		button: Press to reverse the time.
	(Each time the buttons are pressed, the time will be advanced/reversed in
	five-minute increments; hold the buttons depressed to change the time
	quickly in ten-minute increments.)
3	Press the CLOCK ADJUST button (Fig. 6 b-14) again.
	This completes the time setting and starts the clock.

To Use the Remote Control Unit

●The Remote Control Unit must be pointed at signal receiver (Fig. 3 a-4) to operate correctly.

●Operating Range: About 23ft (7 meters).

●When a signal is properly received by the indoor unit, a beeping sound will be heard.

●If no beep is heard, press the Remote Control Unit button again.

Remote Control Unit Holder

Insert	Slide up
Press in	Pull out
Screws
1 Mount the Holder. 2 Set the Remote Control	3 To remove the Remote
Unit.	Control Unit (when use at
	hand).

CAUTION!

●Take care to prevent infants from accidentally swallowing batteries.

●When not using the Remote Control Unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.

●If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of water, and consult your physician.

●Dead batteries should be removed immediately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.

●Do not attempt to recharge dry batteries.

Never mix new and used batteries, or batteries of different types.

Batteries should last about one year under normal use. If the Remote Con- trol Unit’s operating range becomes ap- preciably reduced, replace the batteries and press the RESET button with the tip of a ballpoint pen or other small object.

En-5