Method Of Charging / Repairs
The acceptable method for charging the RAC system is the Weighed in Charge Method. The weighed in charge method is applicable to all units. It is the preferred method to use, as it is the most accurate.
The weighed in method should always be used whenever a charge is removed from a unit such as for a leak repair, compressor replacement, or when there is no refrigerant charge left in the unit. To charge by this method, requires the following steps:
1.Install a piercing valve to remove refrigerant from the sealedsystem. (Piercing valve must be removed from the system before recharging.)
2.Recover Refrigerant in accordance with EPA regulations.
WARNING
BURN HAZARD
Proper safety procedures must be followed, and proper protective clothing must be worn when working with a torch.
Failure to follow these procedures could
UHVXOWLQPRGHUDWHRUVHULRXVLQMXU\
3. Install a process tube to sealed system.
CAUTION
FREEZE HAZARD
Proper safety procedures must be followed, and proper protective clothing must be worn when working with liquid refrigerant.
Failure to follow these procedures could
UHVXOWLQPLQRUWRPRGHUDWHLQMXU\
4.Make necessary repairs to system.
5.Evacuate system to 200 microns or less.
6.Weigh in refrigerant with the property quantity of
7.Start unit, and verify performance.
WARNING
BURN HAZARD
Proper safety procedures must be followed, and proper protective clothing must be worn when working with a torch.
Failure to follow these procedures could
UHVXOWLQPRGHUDWHRUVHULRXVLQMXU\
8. Crimp the process tube and solder the end shut.
31
