Figure F TYPICAL INSTALLATION
TRIM MOULDING
SCREW #12A x 2"
LONG (USE 3)
SILL PLATE GUIDE CHANNEL
INSIDE WALL SURFACE
CAULK ALL SIDES WEATHER TIGHT
" SLOPE DOWN
NOTE: SUPPORT BRACKETS MAY BE OMITTED
FROM
CABINET IS SECURED AS FOLLOWS. DRILL 2 HOLES
IN EACH SIDE AND INSTALL 4 FASTENERS (2 EACH
SIDE). USE #12 x 2" SCREWS, TOGGLE BOLTS OR
EXPANSION ANCHOR BOLTS AS SHOWN IN STEP 7.
CABINET
SUPPORT BRACKETS (AVAILABLE AS OPTIONAL ACCESSORY)
SCREW #12 x 2" LONG, USE ONE EACH BRACKET.
DRILL 5»32 DIA. PILOT HOLES.
STEP 6 Slide the cabinet into the hole far enough to allow the guide- channel of the sill plate to contact the inside wall surface (See Figure F).
STEP 7 Drill three (3) 5 »32" dia. pilot holes through holes in
NOTE: ALTERNATE FASTENERS WHICH MAY BE USED FOR SECURING THE SILL PLATE IN THE WALL AND THE SUPPORT BRACKETS TO THE OUTSIDE WALL (NOT FURNISHED BUT AVAILABLE AT LOCAL HARDWARE STORE).
EXPANSION ANCHOR BOLT
MOLLY OR TOGGLE BOLT
STEP 8 Drill two (2) 5 »32" dia. pilot holes each cabinet side at the locations shown (see Figure F) and install four (4) #12A x 2" screws (Item
#4, page 9). Provided that Step 5 (hole construction) provides a sturdy mount with solid vertical studs, no support brackets are required. The installation must support the weight of the unit plus an additional weight of 400 pounds on the rear of the cabinet.
If support brackets are available, they can certainly be used for
If the reliability of the wall is in question, a window installation kit which includes support brackets can be ordered (see Accessories).
STEP 9 If desired, trim around the cabinet on the room side with a suitable
frame moulding furnished by the installer (see Figure F).
STEP 10 Complete the installation by following steps 13 through 18 of SASH WINDOW INSTALLATION INSTRUCTIONS, pages
STEP 11 Refer to the OPERATION SECTION for instructions.
NOTICE
Instructions for mounting sleeve with slope must be observed to prevent entry of water into room.
17
