Frigidaire 318200879 manual Care & Cleaning, Cleaning the Burner Grates, Burner Caps, Burner Heads

Care & Cleaning

Surface

Burner

Grate

1st

Cleaning the Burner Grates, Burner Caps, Burner Heads

The Burner Grates, Burner Caps, and Burner Heads should be routinely cleaned. Keeping the burner ports clean will prevent improper ignition and an uneven flame at each burner position. Refer to the following instructions:

To Remove and Replace the Surface Burner Grate, Surface Burner Cap and Surface Burner Head - Remove in the following order; (1st) Surface Burner Grate, (2nd) Surface Burner Cap, (3rd) Surface Burner Head (See Figure 1).

Figure 1

Surface	Reverse the procedure above to replace the Surface Burner Cap, Surface Burner
Burner	Head and Surface Burner Grate. Do not remove any burner parts from the
2nd Cap	cooktop until the burner parts have completely cooled and are safe to handle.
	Do not operate the surface burners without the Surface Burner Caps, Surface
Sur-	Burner Heads and Surface Burner Grates properly in place.
face
3rd Burner	To Clean the Burner Caps, Burner Heads and Grates - Use a soap-filled scouring
Head	pad or a mild abrasive cleanser to clean the surface burner caps and surface burner
Electrode	heads. The Grates and the outer vent covers are designed to be Dishwasher safe
	for cleaning. The ports (or slots) around the burner heads must be routinely cleaned.
Orifice
	If residue still remains in these ports, use a small-gauge wire or needle to clean the
holder
	slots or holes. For proper flow of gas and ignition of the burner—DO NOT ALLOW
	SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER
	THE GAS ORIFICE HOLDER OPENING. ALWAYS keep the surface burner cap
	and surface burner head in place whenever a surface burner is in use.

Surface Burner	Surface Burner	Surface Burner	Outer Vent
Grate	Caps	Heads	Covers

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

THE INNER VENT IS NOT REMOVABLE. Do not attempt to remove the inner vent cover.

Use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed ignition or prevent the burner from igniting.

Any additions, changes or conversions required in order for this appliance to perform satisfactorily must be made by authorized servicer.

19