Frigidaire 318201679 (0903), CPDS3085KF U.S.A, Electrical Connection to the Range

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

4. Electrical Connection to the Range

(U.S.A.)

Three Conductor Wire Connection to Range

If local codes permit connection of the frame grounding conductor to the neutral wire of the copper power supply cord (see Figure 3):

1.Remove the 3 screws at the lower end of the rear wire cover, then bend the lower end of the rear wire cover (access cover) upward to expose range terminal connection block (see Figure 2).

2.Using the nuts supplied in the literature package, connect the neutral of the copper power supply cord to the center silver-colored terminal of the terminal block, and connect the other wires to the outer terminals. Match wires and terminals by color (red wires connected to the right terminal, black wires connected to the left terminal) (see figure 3).

3.Lower the terminal cover and replace the 3 screws.

Silver Colored Terminal

Red Wire

Terminal	Cord
Block
	Mounting
	Plate
Black	Neutral
Wire	(White Wire)
	Grounding
	Strap

A User Supplied		1 1/8" (2.9 cm) Dia.
		Direct Connection
Strain-relief Must
	To 240 V	Hole. Punch Out
Be Installed at This
		Knockout for 1 3/8"
Location.	Receptacle
		(3.5 cm) Dia. Cord
	Figure 3	Kit Hole.

Four Conductor Wire Connection to Range

Where local codes does NOT permit connection of the frame grounding conductor to the neutral wire of the copper power supply cord (see Figure 4):

1.Remove the 3 screws at the lower end of the rear wire cover, then raise the lower end of the rear wire cover (access cover) upward to expose range terminal connection block (see figure 2).

2.Remove the grounding strap from the terminal block and from the appliance frame.

3.Using the nuts supplied with the literature package, connect the ground wire (green) of the copper power supply cord to the frame of the appliance with the ground screw, using the hole in the frame where the ground strap was removed (see Figure 4).

4.Connect the neutral of the copper power supply cord to the center silver-colored terminal of the terminal block, and connect the other wires to the outer terminals. Match wires and terminals by color (red wires connected to the right terminal, black wires connected to the left terminal).

5.Lower the terminal cover and replace the 3 screws.

Terminal Block Silver Colored Terminal

Red

Wire

Black Wire
1 1/8" (2.9cm)
Dia. Direct
Connection
Hole. Punch	Neutral
Out Knockout	(White Wire)
for 1 3/8"	Ground (Bare
(3.5cm) Dia.
Cord Kit Hole.	Copper Wire)
A User Supplied
Strain-relief Must
Be Installed at This
Location	To 240 V Receptacle

NOTE: Be sure to remove the supplied grounding strap.

Figure 4

6