Frigidaire CPDS3085KF Models with an Electric Oven and a Gas Cooktop, Example Junction Box

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

Direct Electrical Connection to the Circuit Breaker, Fuse Box or Junction Box

If the appliance is connected directly to the circuit breaker, fuse box or junction box, use flexible, armored or nonmetallic sheathed copper cable (with grounding wire). Supply a U.L. listed strain-relief at each end of the cable. At the appliance end, the cable goes through the Direct Connection Hole (see Figure 5) on the Cord Mounting Plate. Wire sizes (copper wire only) and connections must conform to the rating of the appliance.

A50A time-delay fuse or circuit breaker is recommended (minimum 40A).

Where local codes permit connecting the appliance- grounding conductor to the neutral (white) wire (see Figure 5):

1.Be sure that no power is supplied on the cable from residence.

2.Remove the grounding strap from the terminal block and from the appliance frame.

3.In the circuit breaker, fuse box or junction box:

a)Connect the green (or bare copper) wire, the white appliance cable wire, and the neutral (white) wire together.

b)Connect the 2 black wires together.

c)Connect the 2 red wires together.

Cable from Residence

Neutral		Black
(white) Wire		Wires
Red
Wires
		Junction
		Box
		White Wire
Green		U.L.-listed Conduit
(or Bare Copper)		Connector (or CSA
Wire	Cable from	listed)
	Appliance

NOTE: Be sure to remove the supplied grounding strap.

Figure 5

3-Wire (Grounded Neutral) Electrical System

(Example: Junction Box)

Where local codes DO NOT permit connecting the appliance-grounding conductor to the neutral (white) wire, or if connecting to 4-wire electrical system (see Figure 6):

1.Be sure that no power is supplied on the cable from residence.

2.Remove the grounding strap from the terminal block and from the appliance frame.

3.In the circuit breaker, fuse box or junction box:

a)Connect the white appliance cable wire to the neutral (white) wire.

b)Connect the 2 black wires together.

c)Connect the 2 red wires together.

d)Connect the green (or bare copper) grounding wire to the grounding wire of the circuit breaker, fuse box or junction box.

Cable from Residence

Green (or Bare

Copper) Wire

White Wire

Red

Wires

Black

Wires

Green (or Bare

Copper) Wire

White Wire

Junction	U.L.-listed Conduit
Box
	Connector (or CSA
Cable from
	listed)
Appliance

NOTE: Be sure to remove the supplied grounding strap.

Figure 6 – 4-Wire Electrical System

(Example: Junction Box)

7