DOOR REMOVAL INSTRUCTIONS
Removing Freezer Drawer
1Open freezer drawer.
2Remove drawer screws on right and left sides (two screws on each side).
Remove Hex
Head Drawer
Screw
Do Not Remove |
Other Screws |
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
NOTE
Do not remove center screw from freezer drawer. This is a factory adjustment.
CAUTION
Drawer is heavy. Use caution when lifting. 3 Lift drawer up and out to remove.
Installing Freezer Drawer
1With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side.
Drawer | Fully Extend |
Assembly | |
| Drawer Slides |
Pin | Cabinet |
| |
| Slot |
2Reinstall four drawer screws (two per side), tighten down, and close drawer (C).
Install Screws |
(2) Each Side |
3Check gasket seal around top, bottom, and sides of freezer drawer.
4If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each side) to allow drawer to rotate.
5Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.
Push | Grab Drawer |
At Center | |
Against | From Both |
Freezer | Sides Then |
Drawer | Pull Drawer |
| Out |
A | B |
6Tighten four drawer screws.
7Recheck gasket seal.
8 Install the toe grille by fitting into place.
12
