Frigidaire ES400 manual Sizes of the Surface Gas Burners

Sizes of the Surface Gas Burners

(1) Center

Grate

(4) Surface

BurnerGrates

"POWER"

BurnerHead

Burner Cap

/

			,_<-_	Left Rear			Small
			\	Odflce Holder
	Standard	_
	Burner Head	._
	(9,500 BTU)	1' "	ExtraLarge		_<_"SIMMER"
		Left Front	BurnerCap _,_,_o,		_	Burner Head
		Orifice Holder			/
		"POWER PLUSTM"		....		(5,000 B'RJ)
			BurnerHead --_		_ _
Orifice					RightRear
		0/'_	(14 000 BTU)	_\	Burner Port		....
Holder
				RightFront
	Electrode must be		Odfice Holder
	located properly in slot				Figure 1
Figure 2	at each Burner Head

Centergrateshould lockintothese2 Ioce_ons withsurface gratefingers,

Figure 3

Your gas range was supplied with 4 different surface gas burners; a "SIMMER" Burner (5,000 BTU), a STANDARD burner (9,500 BTU), a "POWER" Burner (12,000 BTU) and a POWER PLUS TM Burner (14,000 BTU). When setting up the gas range for the first time, make sure that the correct Burner Heads, Burner Caps and Burner Grates are correctly (See Fig. 1).

Assembly of the Surface Burner Heads, Burner Caps and Burner Grates:

It is very important to makes sure that all of the Surface Burner Heads,

Surface Burner Caps and Surface Burner Grates are installed correctly and in the correct locations.

1.Place all 4 Burner Heads in the correct locations (See Fig. 1). Make sure that the correct Burner Head is placed with the corresponding Orifice Holder and that the Electrode is located properly in the slot provided of each Burner Head (See Fig. 2). Proper Burner Head placement insures that each Burner will have the correct spark required for gas ignition.

2.Place the correct Burner Caps at each of the burner locations. Each of the 4 Burner Heads MUST have a Burner Cap installed to insure proper ignition and gas flame size before placing the Burner Grates (See Fig. 2).

3.Place the 4 cast iron surface Burner Grates supplied with the range. After the surface grates been installed place the center grate between the four grates and be sure to interlock the grates correctly (See Fig. 3).

REMEMBER --DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR

ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER

OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use.