AUTOMATIC ICE & WATER DISPENSER
Priming the water supply system
CAUTION
For proper dispenser operation, recommended water supply pressure should fall between
30 psi and 100 psi. Excessive pressure may cause water filter to malfunction.
1. Begin filling the
tank by pressing and holding a drinking glass against the water dispenser paddle.
2.Keep the glass in
this position until water comes out of the dispenser.
It may take
about 1½ minutes.
3.Continue dispensing water for about four (4) minutes to flush the system and plumbing connections of any impurities (stopping to empty the glass as necessary).
NOTE
The water dispenser has a
IMPORTANT |
Your ice maker is turned on at the factory |
so it can work as soon as you install your |
refrigerator. If you cannot connect a water |
supply, set the ice maker’s On/Off icon to |
Off and turn off the water supply valve; |
otherwise, the ice maker’s fill valve may make |
a loud chattering noise when it attempts to |
operate without water. |
Turning the fresh food ice maker on and off
Ice production is controlled by the ice maker’s On/Off icon on the control panel. Press and hold the “Ice Off” icon for three (3) seconds to turn the ice maker “ON” or “OFF”. The ice maker is turned off when the LED above the “Ice Off” icon is illuminated.
IMPORTANT
Turning off the ice maker will result in existing ice melting in the bin.
IMPORTANT
Turning off the ice maker will disable the ice dispenser. You will still be able to dispense water.
NOTE
Dispensed water is chilled. For colder water, add ice to cup or container before dispensing water.
Ice maker operation & care
After the refrigerator is installed properly and has cooled for several hours, the ice maker can produce ice within 24 hours. The ice maker will fill the ice bin from the rear. You must dispense some ice to force the ice forward in the bin. This will allow the bin to fill completely.
NOTE
The ice maker also has a
Using the ice maker after installation
Before making ice for the first time, be sure to prime the water supply system. Air in new plumbing lines can result in two (2) or three
(3)empty ice maker cycles. Furthermore, if the system is not flushed, the first ice cubes may be discolored or have an odd flavor.
22