INSTALLATION
Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1.Check gasket seal around top, bottom, and sides of freezer drawer.
2.If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate.
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Do Not Remove Other Screws
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
3.Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.
4.Tighten four (4) drawer screws.
5.Recheck gasket seal.
Push
Against
Freezer
Drawer
A
| Grab |
| Drawer |
| at |
| Center |
| from |
| Both |
| Sides |
| then |
| Pull |
B | Drawer |
Out |
Level Refrigerator & Adjust Doors (if necessary)
Guidelines for final positioning of your refrigerator:
•All four corners of the cabinet must rest firmly on the floor.
•The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly).
•Doors should align with each other and be level.
Most of these conditions can be met by raising or lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer. Lift the toe grille and gently pull forward
(see illustration).
6