DOOR REMOVAL INSTRUCTIONS
NOTE
Do not remove center screw from freezer drawer. This is a factory adjustment.
CAUTION
Drawer is heavy. Use caution when lifting.
1.Lift drawer up and out to remove.
Installing Freezer Drawer
1.With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side.
Push | Grab |
Against | Drawer |
Freezer | at |
Drawer | Center |
| from |
| Both |
| Sides |
| then |
| Pull |
| Drawer |
| Out |
6.Tighten four (4) drawer screws.
7.Recheck gasket seal.
8.Install the toe grille by fitting into place.
Drawer | Fully Extend |
Assembly | |
| Drawer Slides |
Pin
Cabinet
Slot
2.Reinstall four (4) drawer screws (two
(2) per side), tighten down, and close drawer (C).
Install
Screws
(2) Each
Side
3. Check gasket seal around top, bottom, and sides of freezer drawer.
4. If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate.
5. Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.
12
