12
Automatic Ice and Water Dispenser
ICE AND WATER DISPENSER FEATURES
The ice and water dispenser conveniently dispenses chilled water, and ice
cubes or crushed ice, depending on the model. Some models have an Extra
Ice feature that increases ice production for special occasions such as parties.
To operate the ice dispenser, select the ice option desired using the touchpad.
Press a glass against the dispensing paddle as far up as possible to catch
all ice. To stop dispensing ice, pull glass away from dispensing paddle. Do
not remove the glass until the ice has completely dispensed. (Complete
instructions for the dispenser operation are attached to the inside of the
freezer door.)
To operate the water dispenser, press a glass against the dispensing paddle.
To stop dispensing water, pull glass away from dispensing paddle. A drip
tray located at the base of the dispenser, catches small spills and allows
them to evaporate. This drip tray is removable and dishwasher safe. Do not
pour water or excess cubes into this area because there is no drain.
Dispenser Light (some models)
The dispenser has a light which can be turned on and off by pressing the Light
touchpad. The light also turns on automatically when ice and/or water is
dispensed. Replace light bulb with an appliance bulb of the same wattage.
How the Water Dispenser Works
The water tank, located behind the drawers in the refrigerator compartment, automatically fills as water is dispensed. For
proper dispenser operation, the recommended supply water pressure should fall between 20 psi and 100 psi.
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water. It may take about
1½ minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing the system
for 3 minutes to rid the tank and plumbing connections of any impurities. The water dispenser has a built in shutoff device
that will stop the water flow after 3 minutes of continuous use. Simply release the dispenser paddle to reset the shutoff
mechanism.
ON
OFF
Wire
SignalArm
How the Ice Dispenser Works
The ice maker and container are located in the top of the freezer compartment. After the refrigerator is installed properly
and has cooled for several hours, the ice maker can begin making ice within 24 hours. Air in new plumbing lines may cause
the ice maker to cycle two or three times before making a full tray of ice. To begin ice production, lower the wire signal arm
to the "down" or ON position. With no usage it will take approximately 2 days to fill the ice container. The ice maker turns off
automatically when the ice container becomes full. To stop the ice maker, lift the wire signal arm until it clicks, and locks in
the "up" or OFF position.
Because of new plumbing connections, the first production of ice cubes may be discolored or have an odd flavor. These
should be discarded until the cubes made are free of discoloration and taste.
Chemicals from a malfunctioning softener can damage the ice maker. If the ice maker is connected
to soft water, ensure that the softener is maintained and working properly.
Ice and Water Dispenser Panel (features may vary according to model)