4.2.1 Preparation for Use with Filter Paper or Filter Pad

1.Pull the filter pan out from the cabinet and remove the crumb tray, hold-down ring, filter paper and filter screen. (See Figure 1) Clean all components with a solution of detergent and hot water, then dry thoroughly.

The filter pan is equipped with rollers in rails, much like a kitchen drawer. The pan may be removed for cleaning or to gain access to interior components by lifting the front of the pan to disengage the front rollers, then pulling it forward until the rear rollers clear the rails. The pan cover must not be removed except for cleaning, interior access, or to allow a shortening disposal unit (SDU) to be positioned under the drain.

2.Inspect the filter pan connection fitting to ensure that both O-rings are in good condition. (See Figure 2)

3.Then in reverse order, place the metal filter screen in the center of the bottom of the pan, then lay a sheet of filter paper on top of the screen, overlapping on all sides. (See Figure 1) If using a filter pad, ensure the rough side of the pad is up and lay the pad over the screen, making sure that the pad is in between the embossed ridges of the filter pan.

4.Position the hold-down ring over the filter paper and lower the ring into the pan, allowing the paper to rest on the sides of the filter pan. (See Figure 3)

Screen

Filter Paper

Crumb Tray

Hold-Down Ring

Figure 1

Inspect the filter connection fitting O-rings.

Figure 2

Figure 3

4-3

Page 17
Image 17
Frymaster 8195915 operation manual Preparation for Use with Filter Paper or Filter Pad