Frymaster 8195915 Basket lift, movement is noisy, jerky, or erratic, Filter pump wont, start

6.2.3 Basket Lift Problems

Problem	Probable Causes	Corrective Action
Basket lift		Apply a light coating of
	Lack of lubrication on basket lift	Lubriplate™ or similar lightweight
movement is noisy,	rods.	white grease to the rod and
jerky, or erratic.
		bushings.
6.2.4 Filtration Problems
Problem	Probable Causes	Corrective Action
		A. Verify that the power cord is
	A. Power cord is not plugged in or	fully plugged in. If so, verify
	circuit breaker is tripped.	that circuit breaker is not
		tripped.
		B. If the motor is too hot to touch
		for more than a few seconds, the
	B. Pump motor has overheated	thermal overload switch has
	causing the thermal overload	probably tripped. Allow the
Filter pump won't	switch to trip.	motor to cool at least 45
		minutes then press the Pump
start.
		Reset Switch.
	C. Blockage in filter pump.	C. Pump blockages are usually
	Test: Close the drain valve and	caused by sediment buildup in
		the pump due to improperly
	pull the filter pan out from the	sized or installed filter paper
	fryer. Activate the pump. If the	and failure to use the crumb
	pump motor hums for a short time	screen. Call FASC.
	then stops, the probable cause is
	blockage of the pump itself.
Filter pump runs	Blockage in filter pan suction tube.	The blockage may be caused by
		sediment buildup or, if solid
but oil does not	Test: Close the drain valve and pull
		shortening is used, solidified
return to frypot and
	the filter pan out from the fryer.	shortening in the tube. Use a thin,
there is no bubbling
	Activate the pump. If the air or	flexible wire to remove the
oil or air coming
	bubbling oil comes out of the Power	blockage. If the blockage cannot
from the Power
	Shower, there is a blockage in the	be removed, call FASC.
Shower.
	filter pan suction tube.

6-7