Frymaster 8195915 But oil return is very, Slow and bubbling, Oil comes out, Power Shower, From

Problem	Probable Causes	Corrective Action
		A. If using filter paper or pad
		configuration, verify that filter
		screen is in bottom of pan with
Filter pump runs,		paper or pad on top of screen.
but oil return is very	A. Improperly installed filter pan	Verify that o-rings are present
slow and bubbling		and in good condition on filter
	components.
oil comes out of the		pan connection fitting.
Power Shower.		If using Magnasol filter
		assembly, verify that o-ring is
		present and in good condition on
		filter screen fitting.

Problem	Probable Causes	Corrective Action
		B. In order to properly filter, the
		oil or shortening should be at
		or near 350ºF (177ºC). At
		temperatures lower than this,
(continued from		the oil/shortening becomes too
	B. Attempting to filter with oil or	thick to pass through the filter
previous page)		medium easily, resulting in
	shortening that is not hot enough.
		much slower oil return and
		eventual overheating of the
		filter pump motor. Make sure
		oil/shortening is at or near
		frying temperature before
		draining oil into filter pan.
	A. Missing or worn Power Shower	A. Verify that the gasket is present
	gasket.	and in good condition.
		B. If the Power Shower is not
		cleaned on a routine basis,
		sediment will eventually block
		the small holes around the edges
Power Shower not		of the frame. Also, when using
		solid shortening, if the Power
spraying properly.	B. Clogged openings in Power	Shower is not allowed to drain
	Shower frame.	completely, the shortening will
		solidify in the holes and may fill
		the frame. Completely drain the
		Power Shower after each
		filtering and clean regularly in
		accordance with the instructions
		in Chapter 5 of this manual.

6-8