Manuals
/
Frymaster
/
Kitchen Appliance
/
Fryer
Frymaster
CF Series
operation manual
For units equipped with a Computer Magic III.5 Computer
Models:
CF Series
1
24
50
50
Download
50 pages
23.7 Kb
21
22
23
24
25
26
27
28
Install
indicator does not
Warranty
Accessing The Pilot
Start-Up Procedure
Drain and Clean Frypot
Safety
controller power and
Service Hotline
Page 24
Image 24
Page 23
Page 25
Page 24
Image 24
Page 23
Page 25
Contents
Installation and
CF Series
Gas Fryers
APRIL
REQUIREMENTS in Chapter 2 of this manual for specifics
Page
TABLE OF CONTENTS
CHAPTER 2 Installation Instructions
CHAPTER 5 Preventive Maintenance
CHAPTER 6 Operator Troubleshooting
1.2 Parts Ordering and Service Information
CF SERIES GAS FRYERS CHAPTER 1 INTRODUCTION
1.1 Applicability and Validity
1.3 Safety Information
1.4 European Community CE Specific Information
CE Standard for Incoming Gas Pressures
CF SERIES GAS FRYERS CHAPTER 1 INTRODUCTION
1.5 Equipment Description
1.6 Installation, Operating, and Service Personnel
Warranty on your equipment
1.7 Definitions
1.8 Shipping Damage Claim Procedure
CF SERIES GAS FRYERS CHAPTER 2 INSTALLATION INSTRUCTIONS
2.1 General Installation Requirements
The fryers must be installed with a 6 150 mm clearance at both sides and back when installed adjacent to combustible construction no clearance is required when installed adjacent to noncombustible construction. A minimum of 24 600 mm clearance should be provided at the front of the fryer
The type of gas for which the fryer is equipped is stamped on the data plate attached to the inside of the fryer door. Connect a fryer stamped NAT only to natural gas, those stamped PRO only to propane gas, and those stamped MFG only to manufactured gas
2.2 Caster/Leg Installation
2.3 Pre-Connection Preparations
4. Test the fryer electrical system
2.4 Connection to Gas Line
CE Standard
2.5 Converting to Another Gas Type
Non-CE Gas Conversion Instructions
CE Gas Conversion Instructions
2-10
CE Only
Non-CE Only
3.1 Start-Up Procedure
CF SERIES GAS FRYERS CHAPTER 3 OPERATING INSTRUCTIONS
Non-CE Gas Valve
CE Gas Valve
ACCESSING THE PILOT
CF SERIES GAS FRYERS CHAPTER 3 OPERATING INSTRUCTIONS
LIGHTING THE PILOT ON NON-CE FRYERS
least five minutes before attempting to re-light
1. Ensure power to the unit is OFF, and then press the OFF red button. Wait 5 minutes
3.2 Boiling-Out the Frypot
branded locations
5. For units equipped with a Computer Magic III.5 Computer
3.3 Shutting the Fryer Down
3.4 Controller Operation and Programming
CF SERIES GAS FRYERS CHAPTER 4 FILTRATION INSTRUCTIONS
4.1 Draining and Manual Filtering
If you are using a Frymaster filter cone holder, be sure that the cone holder rests securely on the metal container
4.2 Filter Magic II Filtration System Operation
4.2 Filter Magic II Filtration System Operation cont
7. Replace the crumb tray in the filter pan
1. To filter the oil, bring oil to operating temperature and turn the fryer power OFF. Then open the drain valve on the fryer you have selected to be filtered. If necessary, use the Fryer’s Friend steel rod to clear the drain from inside the frypot as necessary
CF SERIES GAS FRYERS CHAPTER 4 FILTRATION INSTRUCTIONS DANGER
of the fryer and may cause injury
Drain handle in the closed position
CF SERIES GAS FRYERS CHAPTER 5 PREVENTATIVE MAINTENANCE
5.1 Fryer Preventive Maintenance Checks and Services
Inspect Fryer and Accessories for Damage
Clean Fryer Cabinet Inside and Out
Check Recovery Time
Clean Float Switch and Shaft
Drain and Clean Frypot
Clean Detachable Parts and Accessories
Clean Gas Valve Vent Tube
Check Thermostat Controller Thermostat Calibration
Check Computer Magic III Set Point Accuracy
Check Burner Manifold Pressure
5.3 Annual/Periodic System Inspection
Fryer
Built-In Filtration System
CF SERIES GAS FRYERS CHAPTER 6 OPERATOR TROUBLESHOOTING
6.1 Introduction
controller power and
Burner will not
light
Solid state analog
indicator does not
indicator is on but
mode. cont
CM III.5 displays
6.3 Troubleshooting Fryers with Thermostat Controls
6.4 Troubleshooting the Built-In Filtration System
Burner does not
Unit will not go into
6.4 Troubleshooting the Built-In Filtration System cont
filtering. cont
Pump starts, but no
transfer takes place
Power Shower is not
or the transfer is very
slow. cont
spraying properly
6.5 Troubleshooting Abnormal Burner Operation
Flame is visible
above flue opening
and burner is
6.6 Replacing the Controller or Controller Wiring Harness
THIS PAGE INTENTIONALLY LEFT BLANK
SERVICE HOTLINE
Shipping Address 8700 Line Avenue, Shreveport, Louisiana
FAX Parts 1-318-219-7140 FAX Tech Support
Price $12.00
Top
Page
Image
Contents
