CF Series
Installation and
Gas Fryers
APRIL
REQUIREMENTS in Chapter 2 of this manual for specifics
Page
CHAPTER 2 Installation Instructions
TABLE OF CONTENTS
CHAPTER 5 Preventive Maintenance
CHAPTER 6 Operator Troubleshooting
CF SERIES GAS FRYERS CHAPTER 1 INTRODUCTION
1.2 Parts Ordering and Service Information
1.1 Applicability and Validity
1.4 European Community CE Specific Information
1.3 Safety Information
CE Standard for Incoming Gas Pressures
CF SERIES GAS FRYERS CHAPTER 1 INTRODUCTION
1.5 Equipment Description
Warranty on your equipment
1.6 Installation, Operating, and Service Personnel
1.7 Definitions
1.8 Shipping Damage Claim Procedure
2.1 General Installation Requirements
CF SERIES GAS FRYERS CHAPTER 2 INSTALLATION INSTRUCTIONS
The fryers must be installed with a 6 150 mm clearance at both sides and back when installed adjacent to combustible construction no clearance is required when installed adjacent to noncombustible construction. A minimum of 24 600 mm clearance should be provided at the front of the fryer
The type of gas for which the fryer is equipped is stamped on the data plate attached to the inside of the fryer door. Connect a fryer stamped NAT only to natural gas, those stamped PRO only to propane gas, and those stamped MFG only to manufactured gas
2.3 Pre-Connection Preparations
2.2 Caster/Leg Installation
4. Test the fryer electrical system
2.4 Connection to Gas Line
CE Standard
2.5 Converting to Another Gas Type
CE Gas Conversion Instructions
Non-CE Gas Conversion Instructions
CE Only
2-10
Non-CE Only
CF SERIES GAS FRYERS CHAPTER 3 OPERATING INSTRUCTIONS
3.1 Start-Up Procedure
Non-CE Gas Valve
CE Gas Valve
CF SERIES GAS FRYERS CHAPTER 3 OPERATING INSTRUCTIONS
ACCESSING THE PILOT
LIGHTING THE PILOT ON NON-CE FRYERS
least five minutes before attempting to re-light
1. Ensure power to the unit is OFF, and then press the OFF red button. Wait 5 minutes
branded locations
3.2 Boiling-Out the Frypot
5. For units equipped with a Computer Magic III.5 Computer
3.4 Controller Operation and Programming
3.3 Shutting the Fryer Down
4.1 Draining and Manual Filtering
CF SERIES GAS FRYERS CHAPTER 4 FILTRATION INSTRUCTIONS
If you are using a Frymaster filter cone holder, be sure that the cone holder rests securely on the metal container
4.2 Filter Magic II Filtration System Operation
4.2 Filter Magic II Filtration System Operation cont
7. Replace the crumb tray in the filter pan
1. To filter the oil, bring oil to operating temperature and turn the fryer power OFF. Then open the drain valve on the fryer you have selected to be filtered. If necessary, use the Fryer’s Friend steel rod to clear the drain from inside the frypot as necessary
of the fryer and may cause injury
CF SERIES GAS FRYERS CHAPTER 4 FILTRATION INSTRUCTIONS DANGER
Drain handle in the closed position
5.1 Fryer Preventive Maintenance Checks and Services
CF SERIES GAS FRYERS CHAPTER 5 PREVENTATIVE MAINTENANCE
Inspect Fryer and Accessories for Damage
Clean Fryer Cabinet Inside and Out
Clean Float Switch and Shaft
Check Recovery Time
Drain and Clean Frypot
Clean Detachable Parts and Accessories
Check Thermostat Controller Thermostat Calibration
Clean Gas Valve Vent Tube
Check Computer Magic III Set Point Accuracy
Check Burner Manifold Pressure
Fryer
5.3 Annual/Periodic System Inspection
Built-In Filtration System
6.1 Introduction
CF SERIES GAS FRYERS CHAPTER 6 OPERATOR TROUBLESHOOTING
Burner will not
controller power and
light
Solid state analog
indicator is on but
indicator does not
mode. cont
CM III.5 displays
6.4 Troubleshooting the Built-In Filtration System
6.3 Troubleshooting Fryers with Thermostat Controls
Burner does not
Unit will not go into
filtering. cont
6.4 Troubleshooting the Built-In Filtration System cont
Pump starts, but no
transfer takes place
or the transfer is very
Power Shower is not
slow. cont
spraying properly
Flame is visible
6.5 Troubleshooting Abnormal Burner Operation
above flue opening
and burner is
6.6 Replacing the Controller or Controller Wiring Harness
THIS PAGE INTENTIONALLY LEFT BLANK
Shipping Address 8700 Line Avenue, Shreveport, Louisiana
SERVICE HOTLINE
FAX Parts 1-318-219-7140 FAX Tech Support
Price $12.00