EH1721 SERIES ELECTRIC FRYERS
CHAPTER 5: OPERATOR TROUBLESHOOTING
5.2.2 Error Messages and Display Problems
Problem | Probable Causes | Corrective Action | |
Display is in wrong |
| Computers may be programmed to | |
| display in either Fahrenheit or Celsius. | ||
temperature scale | Incorrect display option programmed. | ||
Refer to the computer manual that | |||
(Fahrenheit or | |||
| shipped with the fryer for instructions | ||
Celsius). |
| ||
| on changing the display. | ||
|
| ||
CM III.5 |
| Verify that the drain valve is fully | |
or |
| closed. The fryer will not function if | |
Digital Controller | Open drain valve or problem with | the drain valve is not fully closed. If | |
display shows HELP. | the drain valve is fully closed, the | ||
latching circuitry. | |||
problem is within the latching | |||
| |||
display shows |
| circuitry and is beyond the scope of | |
OPEN DRAIN |
| operator troubleshooting. Call FASC. | |
|
| This display is normal if the fryer | |
|
| setpoint has been changed to a lower | |
|
| temperature. The display should | |
| Fryer is more than 21°F (12°C) above | revert to the normal four dashes when | |
Display shows hi. | the frypot temperature cools to the | ||
setpoint. | |||
setpoint. If the setpoint has not been | |||
|
| ||
|
| changed, this indicates a problem with | |
|
| the temperature control circuitry. | |
|
| Turn the fryer off and call FASC. | |
CM III.5 |
|
| |
or |
| This in an indication of a malfunction | |
Digital Controller |
| ||
display shows hot. | Frypot temperature is more than 410°F | in the temperature control circuitry, | |
(210°C) or, in CE countries, 395°F | including a failure of the | ||
(202°C). | thermostat. Shut the fryer down | ||
display shows HI- | |||
TEMP or |
| immediately and call FASC. | |
|
| ||
probe failure. |
|
| |
|
| This display is normal when the fryer | |
|
| is first turned on and may appear for a | |
|
| short while if a large batch of frozen | |
|
| product is added to the frypot. If the | |
CM III.5 |
| display never goes out, the fryer is not | |
| heating. Look for a decimal in the | ||
or | Frypot temperature is more than 21°F | LED display between digits 1 and 2. | |
Digital Controller | If the decimal is present, the computer | ||
(12°C) below setpoint. | |||
display shows lo. | is calling for heat and is functioning | ||
| |||
|
| properly. See Fryer Does Not Heat in | |
|
| Control and Heating Problems | |
|
| (Section 5.2.1). If the decimal is not | |
|
| present, the computer is not calling for | |
|
| heat and may be malfunctioning. Shut | |
|
| the fryer off and call FASC. |