The user may find the booklet “How to Identify and Resolve Radio-TV Interference Problems” help- ful. It is prepared by the Federal Communications Commission and is available from the U.S. Gov- ernment Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4.
2.2Caster/Leg Installation
Depending upon the specific configuration ordered, your unit might have been shipped without in- stalled casters or legs. If casters or legs are installed, you may skip this section and proceed to Sec- tion 2.3,
If your unit requires the installation of casters or legs, install them in accordance with the in- structions included in your accessory package. NOTE: Use only the casters or legs provided by Frymaster for this equipment.
When the fryer is leveled in its final position, install the restraints provided with the unit to limit its movement so that it does not depend on or transmit stress to the electrical conduit or connection. In- stall the restraints in accordance with the provided instructions (see illustration below). If the re- straints are disconnected for service or other reasons, they must be reconnected before the fryer is used.
DANGER
Adequate means must be provided to limit the movement of this appliance without depending on or transmitting stress to the electrical conduit. A restraint kit is pro- vided with the fryer. If the restraint kit is missing contact your local Frymaster Au- thorized Service Agency (ASA) for part number
2.3Pre-Connection Preparations
After the unit has been positioned in the area where it will be used, ensure the following have been accomplished before connecting the unit to the electrical power source:
1.This equipment must be stabilized by installing restraining chains on units equipped with casters or anchor straps on units equipped with legs. Follow the instructions shipped with the cast- ers/legs to properly install the chains or straps.
2.Level units equipped with legs by screwing the legs out ap- proximately one inch, then adjusting them so that the unit is level.
3.The plumbing on the FE155 can be adjusted (See Figure 1) to allow draining on either side. It ships with the drain ex-
Figure 1: Drain shown extended away from unit cabinet.
