![](/images/new-backgrounds/1071253/7125311x1.webp)
E4 SERIES HIGH PRODUCTION RE ELECTRIC FRYERS
CHAPTER 1: SERVICE PROCEDURES
1.1 General
Before performing any maintenance on your Frymaster fryer, disconnect the fryer from the electrical power supply.
When electrical wires are disconnected, it is recommended that they be marked in such a way as to facilitate
1.2 Replacing a Controller
1.Disconnect the fryer from the electrical power supply.
2.The controller bezel is held in place by tabs at the top and bottom. Slide the metal bezel up to disengage the lower tabs. Then slide the bezel down to disengage the upper tabs.
3.Remove the two screws from the upper corners of the control panel. The control panel is hinged at the bottom and swings open from the top.
4.Unplug the wiring harness from the connector on the back of the controller and disconnect the grounding wire from terminal adjacent to the connector. Remove the control panel assembly by lifting it from the hinged slots in the control panel frame.
5.Remove the controller from the control panel assembly and install the replacement controller. Reinstall the control panel assembly by reversing steps 1 and 2.
1.3 Replacing Component Box Components
1.Disconnect the fryer from the electrical power supply.
2.The controller bezel is held in place by tabs at the top and bottom. Slide the metal bezel up to disengage the lower tabs. Then slide the bezel down to disengage the upper tabs.
3.Remove the two screws from the upper corners of the control panel and allow the control panel to swing down.
4.Unplug the wiring harness from the
5.Disconnect the wiring from the component to be replaced, being sure to make a note of where each wire was connected.
6.Dismount the component to be replaced and install the new component, being sure that any required spacers, insulation, washers, etc. are in place.