2

3

4

5

Enter a password not exceeding seven digits.

The password can contain alphanumeric characters.

The entered characters are not displayed and “ ” appears.

The minimum length of user passwords can be set in ‘Set User Password Length.’

After entering a password, press the Enter key.

The cursor moves to the “Enter New Password” field and the utility requests that the password be entered again.

Enter the same password as in Step 2 again and press the Enter key.

The Notice window appears.

Press the Enter key to complete the password setup.

If the reentered password is incorrect, a Warning! window appears. Press the Enter key to retry from Step 2.

To cancel password setup, press the Esc key.

Point

-If the user boots a setup with a user password when the supervisor and user passwords are set, the following items may not appear on the menu:

Set Supervisor Password Diskette access

Fixed disk boot sector

-If the user enters a wrong password three times, the message “System stopped”

is displayed and the PC does not respond to keyboard entry. In such a case, press the Power switch for at least four seconds to turn the PC off. After waiting at least ten seconds, turn the power on again and enter the correct password.

6

7

Exit the BIOS setup utility and turn off the power.

4

Set the jumper switch of the personal computer.

Change jumper switch JP5 from 2-3 to 1-2 on the computer. (For the location of jumper switch JP5, see the following page.)

51