●Boot Time Diagnostic Screen
This item sets whether to display the self diagnostic (POST) screen at boot or reboot.
-Disabled (Initial value)
The FUJITSU logo is displayed at boot or reboot.
-Enabled
The self diagnostic (POST) screen is displayed at boot or reboot.
Point
To confirm BIOS messages from an extension card, select [Enabled].
●Preboot Execution Environment
This item sets whether to preboot from the network server.
-Disabled (Initial value)
Boots the computer from its hard disk drive,
-Enabled
Starts the computer from a network server. If the computer is rebooted after this item is set to [Enabled], “PXE” is added to “Boot Device Priority.”
Point
To boot from the network server, an installation server system conforming to Network PC System Design Guidelines Version 1.0b is required.
●Delay Time for ATA/ATAPI Drive
This item sets the wait time until the computer automatically identifies the ATA/ATAPI drive.
-None
The computer boots automatic identification as soon as it launches.
- 3, 5, 10, 15, 30 seconds (Initial value: 3 seconds) | 4 |
The computer boots automatic identification after a preset time. |
Point
If the computer does not identify the connected ATA or ATAPI drive properly, extend the preset time.
61