CHAPTER 1 RCI Build Procedure

1.3RCI Setup

This section explains the RCI setup for the following cases:

zNew setup for a single RCI Host and two RCI I/O units

zNew setup of two RCI Hosts

zWhen an RCI I/O unit is added later

zWhen a RCI Host is added later

Remarks: Please refer to Appendix A, "Troubleshooting." when there is a problem at RCI setup.

1.3.1New setup for a single RCI Host and two RCI I/O units

RCI Host

RCI I/O unit

RCI I/O unit

Figure 1.5 New setup for a single RCI Host and two RCI I/O units

1Log in to the XSCF Shell.

2Execute the setrci -c stat command to display the RCI status.

XSCF> setrci -c stat

HOST

address 000f7fff Inactive

The command completed successfully

3Verify that the RCI address is 000f7fff.

Remarks: 000f7fff is the default value of the RCI address. If the default value is not set, execute the setrci -c init command to initialize the value.

If the system is powered off, you can use the setrci -c init command.

1-4

C120-E361-04EN