Fujitsu D2630 technical manual Power-Up the Computer, Run the WebBIOS Configuration Utility

Features Replacing the RAID Controller

Step 6 Power-Up the Computer

Replace the computer cover and reconnect the power cord(s). Turn on the computer. Ensure that the SAS and/or SATA II devices are powered up before or at the same time as the host computer. If the host computer is powered up before the SAS or SATA II devices, the devices might not be recognized.

During boot, a MegaRAID BIOS message similar to the following displays:

LSI MEGARAID BIOS VERSION xxxx [date] Copyright(c) 2005, LSI Logic Corporation HA-1 (Bus x Dev y) MegaRAID SAS 8408E PCI-Express RAID Controller Standard FW xxxx DRAM=xxx MB(SDRAM)

Step 7 Run the WebBIOS Configuration Utility

Run the WebBIOS Configuration Utility to configure the physical arrays and logical drives. When the message Press <Ctrl><H> for WebBIOS displays on the screen, press CTRL+H immediately to run the utility.

Step 8 Install the Operating System Driver

The SAS 8408E can operate under various operating systems. To operate under these operating systems, you must install software drivers.

The ServerSupport CD includes drivers for the supported operating systems, along with documentation. You can view the supported operating systems and download the latest drivers for RAID adapters on the web site at: http://service.fujitsu-siemens.com

D2630 (RX600 S3) SAS 27