Fujitsu E-6570 Video Problems, for location, Your operation needs. See Bios Setup Utility on

L i f e B o o k E S e r i e s – S e c t i o n 5

Problem	Possible Cause	Possible Solutions
Your LifeBook appears to	BIOS setup changes were not	Make sure you select Save Changes And Exit when
change setup parameters	saved when you made them	exiting the BIOS setup utility.
when you start it.	and exited the BIOS setup
	utility returning it to
	previous settings.
	The BIOS CMOS hold-up	Contact your support representative for repairs.
	battery has failed.	This is not a user serviceable part but has a normal
		life of 3 to 5 years.
Video Problems
The built-in display is	Something is pushing on the	Clear the Closed Cover switch. (See Figure 2-3 on
blank when you turn on	Closed Cover switch.	page 10 for location)
your LifeBook.
	The LifeBook is set for an	Pressing [F10] while holding down the [Fn] key
	external monitor only.	allows you to change your selection of where to
		send your display video. Each time you press the
		combination of keys you will step to the next
		choice. The choices, in order are: built-in display
		only, external monitor only, both built-in display
		and external monitor.
	The angle of the display	Move the display and the brightness control until
	and the brightness settings	you have adequate visibility.
	are not adequate for your
	lighting conditions.
	The power management time-	Press any button or key on the keyboard, or move
	outs may be set for very short	the mouse to restore operation. If that fails, push the
	intervals and you failed to	Power and Suspend/Resume button. (The display
	notice the display come on	may be shut off by Standy mode, Auto Suspend or
	and go off again.	Video Timeout.)
The LifeBook turned	Power On Self Test (POST)	Contact your support representative.
on with a series of beeps	has detected a failure which
and your built-in display	does not allow the display
is blank.	to operate.
The display goes blank by	The LifeBook has gone into	Press any button or key on the keyboard, or move the
itself after you have been	Video timeout, Standby mode,	mouse to restore operation. If that fails, push the
using it.	Suspend mode or Save-to-Disk	Power and Suspend/Resume button. Check your
	mode because you have not	power management settings, or close your applica-
	used it for a period of time.	tions and go to the Power Savings menu of the setup
		utility to adjust the timeout values to better suit
		your operation needs. (See BIOS Setup Utility on
		page 39 for more information)
	Something is pushing on the	Check the Closed Cover switch. (See Figure 2-3 on
	Closed Cover switch.	page 10 for location)
	The power management time-	Press any button or key on the keyboard, or move the
	outs may be set for very short	mouse to restore operation. If that fails, push the
	intervals and you failed to	Power and Suspend/Resume button. (The display
	notice the display come on	may be shut off by Standby Mode, Auto Suspend or
	and go off again.	Video Timeout.)

76