Fujitsu E-6570 manual Recovery CD, Restoring Your Pre-installed Software from CD-ROM

L i f e B o o k E S e r i e s – S e c t i o n 5

Examples of result codes are:

■OK

■NO CARRIER

■NO DIALTONE

■CONNECT 53000 (Connection complete at 53,000 bps.)

■ERROR

■FAX

■RING (This means an incoming call.)

■BUSY

■NO ANSWER

When using the internal modem with applications that are not factory installed refer to the application documentation.

RECOVERY CD

Included with your LifeBook are the Emergency Recovery CD and Drivers and Application Restore CD.

The Emergency Recovery CD contains the following:

■A backup copy of the software originally installed on your Fujitsu E Series LifeBook.

The Drivers and Application Restore CD contains the following:

■Installation files for pre-installed software

■Sets of device drivers and Fujitsu Applications (in specific directories) that are unique to your LifeBook configuration.

■Read-me files that provide information and installation instructions.

P O I N T

If you have access to the internet, visit the Fujitsu PC Corporation Support Web site at http:// www.8fujitsu.com to check for the most current information, drives and hints on how to perform recovery and system updates.

Restoring Your Pre-installed Software from CD-ROM

The Emergency Recovery CD enables restoration of your LifeBook disk drive contents as they were originally shipped from the factory. Most often this is necessary if files or software programs (only those files/programs that came pre-installed) become corrupt or accidentally erased.

You have two options available when performing recovery:

1.Recover Hard Drive without Format. This choice replaces all the original factory installed files and program structures without eliminating your data files. You will have to reinstall any software that was

not included with the computer when you bought it, however your data will be intact as long as the instal- lation of the additional programs is performed in the same manner.

2.Format and Recover Hard Drive. This choice removes all the information on the hard disk. If you choose this option, you will lose any software you have installed and any other files you created since you setup your computer. You will have to re-install any software that was not included with the computer when you bought it.

P O I N T

It is recommended that you back-up all data files prior to performing either of the recovery options.

C A U T I O N

User data and user installed software CAN NOT be recovered from the Emergency Recovery CD.

To Run the Emergency Recovery Program

To use this portion of the CD-ROM, your LifeBook must Boot up (upon power up or full system reset/restart) from the CD-ROM drive.

1.Insert the Emergency Recovery CD in the CD-ROM drive.

2.If your LifeBook is running when you insert the CD, exit your operating system and power down the LifeBook.

3.Start (power up) your LifeBook.

4.At this point, you must either change your BIOS setup configuration through the [F2] key to have the computer boot from the CD-ROM “first” (if you have not previously done so), or you can use the [ESC] key during this boot-up sequence and select the CD-ROM from the menu that will appear. (See BIOS Setup Utility on page 39 for more information)

5.If correctly configured to boot from the Recovery CD-ROM, you will notice your system running a full virus scan of the hard drive and then reach the Emergency Recovery Welcome screen. If this is not what is displayed, check to see that the Recovery CD is installed in the CD-ROM drive and repeat the previous steps, starting with step 2. If you received a message “This program may not be used on your computer” you are using the wrong Recovery CD for the model of LifeBook. Contact Fujitsu PC Service and Support to obtain the correct CD.

6.Read the information displayed on the Welcome screen, then click OK.

80