Switching On the PC, Switching Off the PC | Fujitsu E623 guide

Operation

Switching On the PC

●If necessary, switch the monitor on (see the operating manual for the monitor).

●Switch the PC on with the main power switch on the rear of the PC.

●Press the ON/OFF switch on the front of the PC.

The power-on indicator lights green and the PC is started.

Switching Off the PC

●Shut down the operating system properly. For Windows: select Shut Down from the Start menu.

●If the operating system does not automatically switch the PC off, turn the PC to ready-to-operate when requested to do so by pressing the ON/OFF switch.

If the PC is ready-to-operate, the PC consumes very little power.

Switch off the PC at the power switch. The PC no longer uses any power.

The main power switch and the power button do not disconnect the PC from the mains voltage. To completely disconnect the mains voltage, remove the power plug from the socket.

●If necessary, switch the monitor off (see the operating manual for the monitor).

10

Image 24

Fujitsu E623 user manual Switching On the PC, Switching Off the PC

Contents

Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe Operation Using this Product for High-Safety Applications Backing Up the Data Microsoft Service Pack Conventions Used in this Manual IntroductionNotational conventions Safety Important NotesManufacturer’s notes Energy saving FCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorTransporting the PC Disposal and recycling Reference to products Xii Organization of This Manual Before Reading This Manual Contents Chapter Steps for Initial Setup Unpacking and Checking the DeliveryExternal devices Drives and boards Setting Up the PC Installing the Feet When two feet double are used Vertical positioning When one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PC Operation Switching On the PC Switching Off the PC Power indicator Front Panels of the Main Unit of the Personal ComputerVent Smart card bay Disc access indicator Floppy disk access indicatorCD access indicator Microphone jack Back Panel of the Main Unit of the Personal Computer AGP card slot Antitheft lockKey hole for a padlock Expansion card slot Main switch OutletInlet LAN port Check that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Installing New Software Mains voltage supply is faultyInternal power supply overloaded Screen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Window XP Wrong RAM modules have been inserted Error Messages on the Screen Restoring the Hard Disk ContentsTime and/or Date is not Correct TipsPage System Expansion System Expansion Information about Boards How to remove the main unit cover Removing the Main Unit Cover Installing Memory Locations for memory to be installed Memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installed Installing expansion cards Press and raise the slot cover lock Remove the slot cover Install the installing fitting Insert the expansion card into the port Replacing Lithium Battery