Time and/or Date is not Correct, Tips | Fujitsu E623 manual

■Time and/or Date is not Correct

You can set the time and date in the BIOS Setup or in the operating system.

●Set the time and date.

If the time and date are repeatedly wrong when you switch on your PC, the on-board battery is flat. Change the lithium battery as described in the "Extensions to the mainboard" - "Replacing lithium battery" chapter.

■Error Messages on the Screen

Error messages and their explanation are contained:

●In the technical manual for the mainboard

●In the "BIOS Setup" manual

●In the documentation for the programmes used

■Restoring the Hard Disk Contents

Should you need to restore your hard disk, the instructions are provided on the case of the "Recovery CD" (delivered with your system).

■Tips

The PC cannot be switched off with the ON/OFF switch

Cause: The PC was not switched on with the ON/OFF switch.

●Press the ON/OFF switch again. Cause: System crash

●Press and hold the ON/OFF switch for at least four seconds until the PC switches off.

Out of system resources

If you have too many applications running at once, you may experience problems due to a lack of system resources. In this case you should:

●close unnecessary applications

or

●run the applications in a different order

21

Image 35

Fujitsu E623 Time and/or Date is not Correct, Error Messages on the Screen, Restoring the Hard Disk Contents, Tips

Contents

Deskpower E623 User’s Manual Important Safety Instructions Iii For Safe Operation Before Reading this Manual Backing Up the Data Using this Product for High-Safety Applications Microsoft Service Pack Notational conventions Conventions Used in this ManualIntroduction Energy saving SafetyImportant Notes Manufacturer’s notes FCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Reference to products Disposal and recycling Xii Before Reading This Manual Organization of This Manual Contents Chapter Drives and boards Steps for Initial SetupUnpacking and Checking the Delivery External devices Installing the Feet Setting Up the PC Vertical positioning When two feet double are used When one foot single is used Horizontal positioning Point Switching on monitor and PC Initial Switch-on Software will be Installed Operation Switching Off the PC Switching On the PC Smart card bay Power indicatorFront Panels of the Main Unit of the Personal Computer Vent Microphone jack Disc access indicatorFloppy disk access indicator CD access indicator Expansion card slot Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Key hole for a padlock LAN port Main switchOutlet Inlet Anti-theft Protection and Lead-sealing Check that the upper cover has been firmly installedPage Troubleshooting Tips Internal power supply overloaded Installing New SoftwareMains voltage supply is faulty Screen stays blank Wrong RAM modules have been inserted No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong monitor has been set under Window XP Tips Error Messages on the ScreenRestoring the Hard Disk Contents Time and/or Date is not CorrectPage System Expansion Information about Boards System Expansion Removing the Main Unit Cover How to remove the main unit cover Installing Memory Table of combinations of memory Locations for memory to be installedMemory to be installed Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Expansion cards to be installed Locations for expansion cards to be installed Press and raise the slot cover lock Remove the slot cover Installing expansion cards Insert the expansion card into the port Install the installing fitting Replacing Lithium Battery