Installing memory | Fujitsu E623 specification

Installing memory

IMPORTANT

Hold the edge of the memory as shown in the following figure. Be sure not to touch the areas (pins) with the indication of golden lines.

Do not touch these areas.

Memory

When installing or removing memory, take care so that the memory does not touch auxiliary fittings.

1Unplug your computer.

2Remove the upper cover.

3Remove the flat cable from the CD-ROM drive.

28

Image 42

Fujitsu E623 user manual Installing memory

Contents

Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe Operation Using this Product for High-Safety Applications Backing Up the Data Microsoft Service Pack Conventions Used in this Manual IntroductionNotational conventions Manufacturer’s notes SafetyImportant Notes Energy saving FCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorTransporting the PC Disposal and recycling Reference to products Xii Organization of This Manual Before Reading This Manual Contents Chapter External devices Steps for Initial SetupUnpacking and Checking the Delivery Drives and boards Setting Up the PC Installing the Feet When two feet double are used Vertical positioning When one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PC Operation Switching On the PC Switching Off the PC Vent Power indicatorFront Panels of the Main Unit of the Personal Computer Smart card bay CD access indicator Disc access indicatorFloppy disk access indicator Microphone jack Key hole for a padlock Back Panel of the Main Unit of the Personal ComputerAGP card slot Antitheft lock Expansion card slot Inlet Main switchOutlet LAN port Check that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Installing New Software Mains voltage supply is faultyInternal power supply overloaded Screen stays blank Wrong monitor has been set under Window XP No Mouse Pointer Displayed on the ScreenFloppy Disk Cannot be Read or Written Wrong RAM modules have been inserted Time and/or Date is not Correct Error Messages on the ScreenRestoring the Hard Disk Contents TipsPage System Expansion System Expansion Information about Boards How to remove the main unit cover Removing the Main Unit Cover Installing Memory Locations for memory to be installed Memory to be installedTable of combinations of memory Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installed Installing expansion cards Press and raise the slot cover lock Remove the slot cover Install the installing fitting Insert the expansion card into the port Replacing Lithium Battery