Install the flat cable into the CD-ROM drive | Fujitsu E623 guide

POINT

Note that reverse insertion may cause failures.

7Return the drive unit in the original position and lock it by pressing the clamp. Remove the stopper supporting the drive unit and return it to the original position.

Check that the metal ports of the unused internal power connector end do not contact with the metal areas so that the wiring from the power unit does not engage with the locking portion.

Stopper

8 Install the flat cable into the CD-ROM drive.

Connect the flat cable removed in Step 3 to the CD-ROM drive.

30

Image 44

Fujitsu E623 user manual Install the flat cable into the CD-ROM drive

Contents

Deskpower E623 User’s Manual Important Safety Instructions Iii Before Reading this Manual For Safe Operation Using this Product for High-Safety Applications Backing Up the Data Microsoft Service Pack Notational conventions Conventions Used in this ManualIntroduction Safety Important NotesManufacturer’s notes Energy saving FCC Class B Compliance Statement Transporting the PC Cleaning the PCCleaning the system unit and the monitor Disposal and recycling Reference to products Xii Organization of This Manual Before Reading This Manual Contents Chapter Steps for Initial Setup Unpacking and Checking the DeliveryExternal devices Drives and boards Setting Up the PC Installing the Feet When two feet double are used Vertical positioning When one foot single is used Horizontal positioning Point Initial Switch-on Software will be Installed Switching on monitor and PC Operation Switching On the PC Switching Off the PC Power indicator Front Panels of the Main Unit of the Personal ComputerVent Smart card bay Disc access indicator Floppy disk access indicatorCD access indicator Microphone jack Back Panel of the Main Unit of the Personal Computer AGP card slot Antitheft lockKey hole for a padlock Expansion card slot Main switch OutletInlet LAN port Check that the upper cover has been firmly installed Anti-theft Protection and Lead-sealingPage Troubleshooting Tips Internal power supply overloaded Installing New SoftwareMains voltage supply is faulty Screen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Window XP Wrong RAM modules have been inserted Error Messages on the Screen Restoring the Hard Disk ContentsTime and/or Date is not Correct TipsPage System Expansion System Expansion Information about Boards How to remove the main unit cover Removing the Main Unit Cover Installing Memory Table of combinations of memory Locations for memory to be installedMemory to be installed Installing memory Page Install the flat cable into the CD-ROM drive Install the upper cover Installing the Expansion Card Locations for expansion cards to be installed Expansion cards to be installed Installing expansion cards Press and raise the slot cover lock Remove the slot cover Install the installing fitting Insert the expansion card into the port Replacing Lithium Battery