Manual Feed Mode Setting

In this mode, the scanner waits for some predetermined time before issuing a “Paper Empty” message after all documents are read. This predetermined time (time-out limit) is specified in the Setup mode. Therefore, you can set the next documents on the ADF chute without interrupting the reading opera- tion. The procedures for setting the manual feed mode are as follows:

<Screen M1>

1Turn the power On and verify that

“Scanner Ready” is displayed on the LCD.

<Screen M2>

2Press then the scanner displays

Screen M2.

NOTICE

The “Mode Select 0” screen is skipped when your scanner is controlled through the SCSI interface.

<Screen M3>

3Press then the scanner displays Screen M3.

<Screen M4>

4Press then the scanner displays

Screen M4.

5Select “Yes” by pressing . Then press .

<Screen M1>

6Press to return to the “Scanner

Ready” screen. Note that “Manual Feed” is shown on the LCD. This means that the scanner is in Manual Feed mode.

3-3

Page 37
Image 37
Fujitsu fi-4750L manual Manual Feed Mode Setting