Appendix1 TROUBLESHOOTING
■Troubleshooting checklist
Symptom | Check this item | Remedy |
|
|
|
Scanner does not turn on. | Have you pushed the power button? | Push the power button. |
|
|
|
| Are the AC cable and AC adapter prop- | Correctly connect the AC cable and the AC |
| erly connected to the scanner? | adapter. |
|
| Disconnect the AC cable and the AC adapter from |
|
| the scanner, then connect them again. |
|
| If this does not restore the power supply, contact |
|
| the store where you purchased the scanner or an |
|
| authorized FUJITSU scanner service provider. |
| Is Windows normally started up? | Push the power button again after completely |
|
| starting up Windows. |
Scanning does not start. | Are the documents loaded correctly on | Load the document correctly on ADF paper chute. |
| the ADF paper chute? |
|
| Is the ADF closed completely? | Close the ADF completely. |
|
|
|
| Is the USB cable or SCSI cable properly | Correctly connect the cable. (When a USB hub is |
| connected? | used, check the hub's power supply.) |
| (When using SCSI interface) Is SCSI ID | Set SCSI ID correctly by SCSI ID switch on rear |
| set correctly? | of scanner. |
| Does the Function Number Display indi- | When the Function Number Display indicates an |
| cates an alarm or an error? | alarm or an error, refer to the "Chapter 5. TROU- |
|
| BLESHOOTING" in the |
|
| Guide for removing the alarm or the error. |
|
|
|
| Does the alarm state remain displayed | Turn off and on the power button. |
| even after the scanner has been turned | If this does not eliminate the alarm state, contact |
| off and back on again? | the store where you purchased the scanner or an |
|
| authorized FUJITSU scanner service provider. |
Vertical lines appear in the | Is the glass dirty? | Clean the glass following the instructions in the |
generated image of the |
| Operator's Guide "3. Daily Care". |
scanned image. |
|
|
|
|
|
The generated image shifts | Are the documents loaded correctly? | Load the documents correctly. |
or is distorted. |
|
|
|
|
|
Quality of generated image | Are the glass or sheet guides (a white | Clean dirty locations. |
is unsatisfactory. | location) clean? |
|
|
|
|
Multi feed frequently | Do the documents satisfy the "Docu- | Use the documents that satisfy the "Document |
occurs. | ment Quality" and the "Multi feed | Quality" and the "Multi feed Detection Condi- |
| Detection Conditions" in the chapter 6 | tions" in the chapter 6 of the |
| of the | Guide. |
| Are the documents set properly in the | Fan the documents before scanning. Correctly |
| ADF paper chute? | align the document stack and load them on the |
|
| ADF paper chute. Refer to "2.1 Installing the |
|
| Scanner" on page 3 for details. |
| Is the document stack thicker than | Reduce the number of sheets in the document |
| 10mm? | stack to 10 mm thickness or less. |
| Is the Pad ASSY dirty? | Clean the Pad ASSY. Refer to the Operator's |
|
| Guide "3.2. Cleaning the ADF". |
| Is the Pad ASSY worn out? | Replace the Pad ASSY. Refer to the Operator's |
|
| Guide "4.2. Replacing the Pad ASSY". |
|
| |
|